Question about 2006 Pontiac Grand Prix
Where is the Vent Door Actuator located on a Pontiac Grand Prix? How do I access it?
You must remove the dash from the car to access the door and the actuator.
Posted on Jun 29, 2012
lock smith or someone authorized to use a slimjim[can do more damage if dont know how to use ]--or-- key fob wont work if vehicle battery dead if u can reach up under car at front and release hood latch then jump battery and then use key fob to unlock door
Posted on Feb 20, 2010
Testimonial: "thank u"
Yes, You can buy a manual at your lacal parts store.
However, It's not that hard. But , you didn't say if you
need to change the front or rear pads?
I'll assume your refering to the front.
1st You'll need to jack up the car if you only have one
Jack then, pick the side you are too start say left front.
Jack the car up like chainging a tire BUT, Jack the car
up but, leave the tire touching the ground with, some weight
still on the tire with a lug rench turn the lug nuts JUST enought
to loosin the nut DO NOT take the nut off, maybe 1/4 " only.
Do the same on the others. Now, Jack up the car until the tire
is off the ground. NOW, Put a Jack Stand under the car never
NOT use a stand. Remove the nuts and tire.
Turn the wheel to the right it will give you more room to work.
You'll need to remove the caliper that holds the pads on.
There are two screws that hold the caliper on. I believe,
there 13mm remove the screws (Take them all the way OUT)
Remove, The caliper the pads, will stay in the holder.
Remove, the pads you may need a screw driver to get the
pads out.There are two pads that have a scencer on them
one for each side PUT that pad on the inside holder.( sencer down)
NOW rember you need, too make room for te new pads.
You need a c- clamp to push the piston BACK into the
bottom of the caliper. Be sure the piston is at the bottom of the caliper
or the caliper will NOT fit back on. Install the new pads into the holder.
.Then, put the caliper back on to it's mount over the new pads.
Put the two caliper bolts back and, your done.
Reverse, the infromation from the top.
Posted on Jan 02, 2010
Testimonial: "Thank u"
Have you checked the coolant level? If that checks out ok... With the engine fully warmed up touch the heater core hoses where they go into the fire wall (about the center of the firewall). They both should be pretty hot to the touch. You'll likely find one hot and one warm. If this is the case flushing the heater core will likely get your heat blowing out hot again.
Posted on Mar 07, 2010
Tips for a great answer:
Jan 16, 2016 | Pontiac Cars & Trucks
Jan 12, 2016 | Pontiac Cars & Trucks
Nov 30, 2017 | 2006 Pontiac Grand Prix
May 06, 2011 | 2006 Pontiac Torrent
Jan 30, 2011 | 2002 Pontiac Grand Prix
Jan 26, 2011 | 2006 Pontiac Grand Prix
Apr 14, 2010 | 2006 Pontiac Grand Prix
Sep 27, 2009 | 2000 Pontiac Grand Am GT
370 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: