If the check engine light is on the other light's Will appear need to be scaned for fault codes
Okay I understand that you did an awesome brake job on the vehicle but there's a lot of steps to technicians take that normal people don't even think about when you do that type of work so you just have to make sure that there's no air in the system cuz if you have air in your braking system and the air is trying to compress with that brake fluid it's not going to be pretty you need to follow the breaking sequence and I would definitely make sure that there's no air in all the work that I did because you never mentioned anything about bleeding the system it's a necessity
Have the vehicle checked for DTC'S - diagnostic trouble code's , lights on codes are stored . The code or codes will point to a diagnostic direction
SOURCE: brake pad replacement 2006 pacifica
They have not Changed Very much from the Old School Disc Brakes. You should have no Problems! Please Rate My Response! Thanks!
SOURCE: ABS,Traction control and brake light stay on. '01Town and Country
it is the vehicle speed sensor cuase your problem
SOURCE: abs light comes on while driving @60 mph, then it
Take it back to the person that supposedly changed your pads and complain that something is grinding now.......make them fix it right!
SOURCE: Engine light and ABS traction control light remain
The ABS sensor is a speed sensor also for Traction Control. This is why both lights are on , One of your front ABS sensors are bad or disconnected, or has a pinched wire.
SOURCE: Change Front Brake pads
(10) Install master cylinder fluid reservoir cap.
Hope this helps...I know it's extremely difficult to find manuals for these cars. These instructions are straight out of the factory service manual.
545 views
Usually answered in minutes!
×