Where is the ac compressor relay on 2000 ford expedition

SOURCE: 2000 Ford expedition window problem

Sounds like you need a window motor. Try hitting in center of door trim panel to see if you can get it to work if so replace motor.

SOURCE: where is the front fan blower relay located in my

I'm guessing under the hood, in the power distribution box. If you look around the engine compartment you'll see what looks like a bigger fuse box. After removing the cover you'll see some bigger fuses and relays. I'm not sure which relay is the one you want. Try a Chilton manual, it'll give you much better detail.

SOURCE: AC system, compressor not engaging.

Sounds like your a/c system is low on freon, system has a low pressure switch which disables a/c compr.so that it don't damage a/c compr, it would be kind of like running an engine with on oil it would damage an engine, what needs to be done is have dye injected in to a/c system to be able to fine the leak, once leak is found can be repaired and recharge with freon, system will work good after repair has been done.Good luck

SOURCE: No heat in my 2000 ford expedition

You should check your blend door, go to the center of your dash look down towards the floor right at the bottom on the hump (tunnel area) you will see a black or same as interior color, cover it has small slits cut in it, it is held in by two expanding type plastic bolts, they do not unscrew, just pull them out, one on each side. Once removed locate the white small box with a wiring harness connected to it, a little to the right hand side. This is the stepping motor that controls the blend door. Remove the stepping motor, and reconnect the harness, look at the motor drive unit and operate the heater control knob, does the motor turn, if it does then use a mirror and look at the drive end of the blend door itself, it is probably broken. If the door is broken, this repair just got difficult, the entire dash will have to be removed to access the environmental station, once accessed there are about 10 screws that hold the top cover on the enviromental station, undo these screws and remove the top cover, then you can remove and replace the blend door. If you are not comfortable with this difficultly level in repair I suggest you seek out your favorite local shop. removing the dash is not easy, there are alot of screws, some in very difficult places to reach. Testing the motor is easy. I hope this helps, let me know.

steve titus

• 277 Answers
• Posted on Mar 02, 2011

SOURCE: 2000 Ford Expedition 4.6L 2wd , compass & outside temp indicator

These consoles are notorious for going bad. You can get a new one at the dealership for $250 (!!!), grab one from a wrecker, or I offer a repair solution with a lifetime guarantee. Check out www.autoclockrepair.com I have removal instructions and info there. Please let me know if I can be of further help, thanks!