SOURCE: Want to remove the ignition lock cylinder since a broken key is stuck inside.
get a phillipshead un do about 4 screws from underneath plastic cover which hides steering colume. remove cover you will see white plug on the left hand side of ignition barrel disconect.then right hand side there will be acable disconect.now get a small chissel and anti clockwise tap bolts which have no heads on them that are on top of steering colume when they are alittle bit lose use plyers its easier pull bolts out clamp will then come of and then you can pull whole ignition of. now there is 2 brass pins which hold barrel in ignition up near the key end remove and barrel will come out but it might be easier to take whole ignition to locksmith and get them to do it and get new key for around 30 bucks i did a mates about couple months ago seeya orangepeel.
SOURCE: mercedes c220 ignition key stopped working
Hi! Sounds like the key needs to be coded again, take all relvant details i.e. chassis vin number, Registration document (Title) and key to your local Mercedes Dealership and hopefully they'll rec-code it for youor replace it.
Good Luck and a Happy New Year to You and your family.
Remember the blue FixYa button?
Paul 'W'
SOURCE: 1995 Mercedes Benz C220 will not start, and key
hello,steering lock mechanism and your key need to replaced,if you want try to remove your under dash,steering lock mechanism have a small pin(around 5 mm) which pit to steering housing,drill out the lock,then try to turn steering wheel,ty
SOURCE: Need to replace the 1995 toyota corolla ignition lock cylinder
You need to pull the plastic covers from above and below the steering wheel off. Then put your key in the ignition and turn it to the acc position, then there is a small button either on the top or bottom of the tumbler assembly, it will be inset and you will need a small pointy screwdriver or something to reach it. When you push the button the ignition assembly and the key will come out together
361 views
Usually answered in minutes!
×