SOURCE: how to reset service light for BMW e90 320i in
This is for 2001 onwards :
- Iginition OFF (POS 0) with key in.
- Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)
- Keep the button depressed (about 5 secs.) until you see "Oil Service" or "Inspection" with "Reset" or "Re" in the display
- *Note: On vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service
- Press the button again and hold for approx. 5 secs. until "Reset" or "Re" flashes
- While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 secs.
Note that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset.
You can find more information at:
http://www.bmwtips.com/tipsntricks/reset-plug/reset.htm
SOURCE: BMW 5 series - 2005 model - resetting service & waring lights
the brake pad warning light is controlled by a sensor located in the front and rear brake pads, small contact with 2 wires that plud into a harness, if they are bad I think the replacement cost is around 5-10 dollars for a new one, there will only be one in the front and one in the rear, the service light is turned out by a special tool at the dealer
SOURCE: BMW 5 series - 2005 model - resetting service & waring lights
this needs to be done with a european capable scan tool,check around to see if someone has this tool, no other way sorry
SOURCE: I replace brake lining on bmw 325xi 2006. How do I
Unfortunately, you have to have the service reset tool. Dealers and BMW mechanics have this tool, but i don't know whether they reset for free. i guess it depends on who you take it to.
Regards,
matt
SOURCE: How do you reset the Service light on 2006 BMW 325
Hi , to reset the service light you will need to insert the key and turn the ignition lights on but do not start the engine. you will see a push button on the lower left side of the instrument panel press and hold this until you have a triangle appear which then turns to the brake warning symbol , release the push button then press and hold the bc button in the indicator arm until reset appears , release and again press and hold the bc button until you have a moving clock symbol appear , release the bc button and wait for the display to change , once this has reset turn off the ignition and the service symbol should have reset . you may want to print these instructions before resetting , regards Mark.
583 views
Usually answered in minutes!
×