Crankshaft torque for yd25 - 2007 Nissan Navara 2.5

The torque settings for the Nissan Urvan YD25 engine are as follows: Cylinder head Bolts: 27Nm (20 ft lbs) Intake manifold Bolts: 7Nm (5.2 ft lbs) Exhaust manifold Bolts: 7Nm (5.2 ft lbs) Oil Pan Bolts: 7Nm (5.2 ft lbs) Oil Drain Plug: 25Nm (18.4 ft lbs) Timing Chain Tensioner Bolts: 7Nm (5.2 ft lbs) Camshaft Sprocket Bolts: 25Nm (18.4 ft lbs) Crankshaft Pulley Bolt: 215Nm (159.2 ft lbs)

4000 rpm

Start here:

2005 nissan d22 yd25 fault codes Google Search

NEXT HUNT HERE!

2005 nissan d22 yd25 fault codes Google Search

I HOPE this helps!
Anthony

Mitsubishi Mighty Max crankshaft bolt Questions & Answers ...

www.fixya.com > ... > crankshaft bolt > Cars & Trucks > Mitsubishi

Mitsubishi Mighty Max cars & trucks crankshaft bolt questions and answers. ...Torque specs for mighty max The head torque specs for 1991 mitsubishi mighty max 2.4 I ... 1989 mitsubishi 2.0 motor crankshaft was turned while timeing belt was off. ...how to install a clutch kit on my 1994 mitsubishi mighty max Disconnect the .

B: INSTALLATION
1) Install the crankshaft pulley.
2) Install the pulley bolt.
To lock the crankshaft, use ST.
ST 499977400 CRANKSHAFT PULLEY
WRENCH
(1) Clean the crankshaft pulley thread using an
air gun.
(2) Apply engine oil to the crankshaft pulley bolt
seat and thread.
(3) Tighten the bolts temporarily with tightening
torque of 44 N·m (4.5 kgf-m, 33 ft-lb).
(4) Tighten the crankshaft pulley bolts.
Tightening torque:
127 N·m (13 kgf-m, 94.0 ft-lb)

From FSM:

B: INSTALLATION
1) Install the crankshaft pulley.
2) Install the pulley bolt.
To lock the crankshaft, use ST.
ST 499977400 CRANKSHAFT PULLEY
WRENCH
(1) Clean the crankshaft pulley thread using an
air gun.
(2) Apply engine oil to the crankshaft pulley bolt
seat and thread.
(3) Tighten the bolts temporarily with tightening
torque of 44 N·m (4.5 kgf-m, 33 ft-lb).
(4) Tighten the crankshaft pulley bolts.
Tightening torque:
127 N·m (13 kgf-m, 94.0 ft-lb)

Is there a diagram for head bolt sequence nissan frontier 2005 2.5 yd25 turbo diesel?

If YD25 diesel then 39NM +90deg +90deg, slacken and redo same in 6stages

If 4L petrol V6 then 48NM, 98NM, slacken off then 39NM +90deg +90deg in 5 stages.

main bearings torque is 18 ft lbs. plus 90 - 94 degrees, rod bearings torque is 13 - 16 ft lbs. plus 90 - 94 degrees.crankshaft damper bolt torque 80 - 94 ft lbs, fly wheel bolts torques 94 - 101 ft lbs.