Question about Dodge Intrepid
I Manuely checked it with the dash lights, and got this code, P0622 Generator Field "F" Control Circuit Malfunction. how do i fix it?
Code 12 is: Direct battery input to PCM was disconnected within the last 50 key-on cycles.
Code 21 is: Neither rich nor lean condition detected from the oxygen sensor input or oxygen sensor input voltage maintained above the normal operating range.
Posted on May 23, 2008
You need a charcoal canister and vent control valve.
You also need the EGR solenoid valve (I think it the brown one).
Valve is located in the valley of the V, towards the transmission side of engine.
Do these 1st and reset light. You may have other issues but you have to start here.
Posted on Sep 16, 2008
More then likely its the Canister Purge Solenoid. you can find it online at www.autozone.com the part number is PV140. And to replace it on blazer you have to remove the spare tire. Alot of people don't know where this part is so I hope this helps you and good luck.
Posted on Oct 14, 2008
DO U UNDERSTAND THE MEANING OF "OUT OF PHASE"?? IT IS THE MECHANICAL TIMING OF THE SIGNAL FROM EACH SENSOR TO THE ENGINE CONTROL COMPUTER, WHAT IS THE CODE? ALSO TELL YOUR DAD (NICELY) THAT ATROUBLE CODE DOES NOT ALWAYS MEANS A FAILED SENSOR, ONLY A PROBLEM WITH THE SIGNAL, THAT CAN BE THE WIRING, IT CAN BE MECHANICAL OR IT CAN BE THE SENSOR, MANY POEPLE DON'T GET THAT AND SPEND TON'S OF MONEY CHASING CODES.I HAVE DONE THIS FOR 35 YEARS AND AM SURE OF WHAT I AM SAYING 100%
Posted on May 08, 2009
Tips for a great answer:
Feb 22, 2018 | Dodge Cars & Trucks
Aug 11, 2015 | 1993 Dodge Dakota
Jul 24, 2014 | 2001 Dodge Intrepid
Apr 18, 2014 | 2001 Dodge Intrepid
Apr 16, 2014 | 2001 Dodge Intrepid
Jul 15, 2013 | 2005 Dodge Neon SXT
Apr 28, 2013 | 2001 Dodge Dakota
Thermostat Rationality Test
Check the operation of the thermostat (it may be stuck open).ECT Sensor is contaminated, damaged or it has failed.Inspect for low coolant level or for an incorrect coolant mixture.Trouble Code: P0440
EVAP Purge System Fault
EVAP purge valve vacuum supply is leaking or clogged.EVAP purge valve is stuck closed.EVAP purge solenoid has failed.NVLD assembly (leak detection) is damaged or has failed.NVLD switch circuit is open or the NVLD switch has failed.Ground circuit is open.PCM has failed.Trouble Code: P0456
EVAP Small Leak (0.020") Detected
.EVAP fuel tank or canister vapor hoses leaking or damaged.EVAP system component leaking, fuel cap loose or missing.Leak detection pump damaged or leaking.Trouble Code: P0622
Generator Field Control Circuit Malfunction
Generator field control circuit is open or is shorted to ground.Generator field control circuit is shorted to system power (B+).Generator field ground circuit is open.Generator is damaged or PCM has failed.PCM has failed.Here are the codes and causes.
Nov 25, 2012 | 2002 Dodge Intrepid
Sep 29, 2012 | Chrysler PT Cruiser Cars & Trucks
840 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: