SOURCE: diagram for serpentine belt for 2002 BMW 525i
An image of a serpentine belt, hope this will help you,
Eitan.
SOURCE: water pump
I replaced the water pump on my 1997 740i without a manual & so can you! Go to e38.org for instructions with pictures. Read up & get prepared with the parts & tools that you will need. Not a very difficult job, but take your time to do it properly. Good luck!
SOURCE: how to replace a water pump on a 1995 bmw 318is
-Disconnect the negative battery cable.
-Drain the cooling system.
-Remove the distributor cap and rotor. Remove the rotor adapter, the dust shield and the distributor housing.
-Remove the fan. The fan must be held stationary with tool 11 5
030 or some sort of flat blade cut to fit over the hub and drilled to
fit over 2 of the studs on the front of the pulley. Remove the fan
coupling nut; left hand thread-turn clockwise to remove.
-Remove the belt and pulley.
-Remove the rubber guard and distributor and or upper timing belt cover.
-Compress the timing tensioner spring and clamp pin with the proper tool.
*Observe the installed position of the tensioner spring pin on the water pump housing for reinstallation purposes.*
-Remove the water hoses, remove the 3 water pump bolts and remove the pump.
SOURCE: bmw e46 2000 model 'how to remove water pump?'
Follow link. Leave positve comment..Thanks
http://www.alldatapro.com/alldata/PRO~V148476721~C35987~R0~OD~N/0/77993956/77993988/83334025/83334028/34853741/100411974/34856156/34856543/34849613
SOURCE: replaced water pump in 2001 bmw z3 and now car won't start
I would suspect that you pulled a wire off when you were installing the water pump. Check to see if you have spark
219 views
Usually answered in minutes!
×