Question about 1998 Chevrolet Venture Cargo

1 Answer

Passenger side seat belt is locked.can;t even pull it an inch.

How can i fix it so i can use it again.1998 chevy venture van.it was working fine before.

Posted by tracey_101_8 on

Ad

1 Answer

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 99 Answers

Take seat belt loose at floorboard and check to see if anything is stuck in mechanism, sometimes the rachet spring will break and a ne seat belt is in order

Posted on Nov 30, 2008

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace an ignition switch on a 2002 chevy venture van? I have a 2002 chevy venture van and have had a problem with the starter staying engaged. I replaced the started and it fixed it...


So what it only does it in park or neutral ! The vehicle starting circuit is only suppose to let it start in park or neutal . Park neutral safety switch won't allow B+ voltage to S terminal on the starter solenoid unless the vehicle is in park or neutral . It's probably the starter relay contacts stuck closed . You really should learn how it works before guessing as to the problem . Plus learn automotive electrical testing ! The ignition switch when turned to the start position send's a voltage signal to the PCM - engine computer .The PCM will energize the starter relay to crank the engine . PCM / ABS 10amp fuse in the I/P fuse box supply's B+ voltage to the park / neutral safety switch . When in park or neutral the B+ voltage goes through the control side of the relay to the PCM which will supply a ground to energize the starter relay .

Jun 17, 2017 | 2002 Chevrolet Venture Passanger

1 Answer

I need a diagram of how to install an oil pump on a 1998 Chevy Venture Van, please.


kslib.info go to I'm looking for.....pick autorepair chilton. its free

Jan 16, 2010 | 1998 Chevrolet Venture Cargo

1 Answer

2001venture van service engine soon light stays on


most any sensor going bad can cause the check engine light to come on,try disconnecting the posative battery cable for 15 seconds ,then put it back on,will reset the codes, or take it to auto zone,they will test your computer for codes at no charge to you.i had a venture van my was ox. sensor. thanks robert b.

Jun 16, 2009 | 1998 Chevrolet Venture Cargo

1 Answer

1998 chevy venture van....check engine light came on


This means that you need to Replace the Catalytic Converter. Please Rate My Response! Thanks!

Jan 31, 2009 | 1998 Chevrolet Venture Cargo

2 Answers

Thermostat in a 2003 chevy venture van


no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.

Nov 27, 2008 | 2004 Chevrolet Venture Passanger

2 Answers

Lights dimming and brightening on 2000 Chevy Venture


2000 chevy venture run good but my lights flickers and have to jump. After I jump the van and put my meeter on the battery its reading 14.volts at idle. I can drive around to store cut the van off come out it starts fine leave it overnite and it don't started.

Nov 21, 2008 | 1999 Chevrolet Venture

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

562 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...