Where is windshield wiper relay 1999 vw jetta

SOURCE: Windshield Wipers stop half cycle

relay location 10
191-955-531 part #

Posted on Feb 18, 2009

SOURCE: Signal and windshield wiper aren't working

switch in steerig console combo wiper turn?

Posted on Mar 01, 2009

SOURCE: steps for replacing wiper motor for 1998 VW Jetta

remove wipers. remove plastic covering by loosening plastic screws first. unplug wiper motor wires. there are about three 10mm nuts at the motor location and you also have to unscrew the big nuts that were below the wipers when you unscrewed them. replacement is reversal.

Posted on Mar 26, 2009

steve morris

• 1675 Answers

SOURCE: 2000 VW jetta VR6 windshield wipers wont work

first try the fues box see if you have a blown fues, next if you put your wipers on can you hear the motor running for them? if you can the linkage has poped off from the motor, its a bit awkward to get it back on and no gaurentee that it will saty on, you might have to replace linkage, or, it might be the cogs on the actual wiper arms have splayed and are now smooth so they dont grip to move, you can take them off by the nut on the arm , get a can (coke can or simular) cut a rectangle out of it the hight and width if the cog, rap it round the cog, (make sure it does not overlap on the ends) and force the arm back into place and then do the nut up, this is just a short quick fix if that is the case you will have to replace the motor, also you can check the relay to the motor in the fues box, give it a tap a couple of times it might work again if not replace it...hope you find these sugestions helpful

Posted on Feb 08, 2010

SOURCE: windshield wipers on 2007 VW jetta not swiping

wiper gears may be broken, got to junk yard and buy motor and gear assembly for windshield wipers, should only take an hour to change out.

Posted on Feb 15, 2010