SOURCE: noise in front end, sounds
You say the rear wheel axles and bearings have been replaced, you mention nothing of the front wheels, you have the symptoms of a front wheel bearing being worn out, remove them and check for pitting in the bearing rollers or the bearing races, I am sure you will find a problem. Hope this helps solve your issue with the bearing noise.
SOURCE: clanking noise under front drivers side - small bumps and turns...
CV joints yes look at the rubber boots for damage. You can get a replacement boot but if you do remove all the old grease to remove any dirt that is cousing your problem.
SOURCE: my 2006 Ford F-150 has a grinding noise in the
Sounds like you have a IWE that the gears are ground down, or a bad vacuum line to that side.
This could have been caused by the IWE ( Integrated Wheel End ) solenoid ) TSB :
http://my.voyager.net/~sscully/file_tsb06_08_15.pdf
You can check the vacuum line with a vacuum pump and gauge tester, just to be sure, but considering it is grinding while in 4WD, I would say the IWE needs to be replaced on that side. Maybe change the IWE solenoid while you are doing the work ( it will be a rounding error on the total cost )
SOURCE: my 2006 ford fusion right
The EXACT same signal light problem started on my 07 Ford Fusion yesterday. Had to pull the right bulb to save the battery last night. Which is why I'm on here: Ford dealer wants $99/hr to diagnose... my family can't eat mac and cheese for a month. The solutions so far don't seem too confident. Any luck?
748 views
Usually answered in minutes!
×