Did you replace the window controller in the drivers door? The one on the driver side controls both. If you did, then you have to replace the one on the passenger door. Both have to work, for it to work. I put the addition info for anyone that has the same problem.
SOURCE: 1998 Honda CRV Drivers side window(power)
Did you check for power and ground at the window motor connector before you replaced it? Apparently not....
SOURCE: 1996 honda civic lx passanger power window problem
I had this problem as well as 33 others I've spoken to online. The main floor harness runs thru the drivers side front fender and plugs into the drivers door. The harness in 1996 civics are an inch or 2 too short so after a few years a few of the 25 thru 27 wires in the plug #C556 either break off or pull out of the plug. Since the drivers door contains the master power window and lock switches and the power mirrors can also be affected it can seem like everyones problems are in different parts of the car but they are all part of the same default. So I went to ebay and purchased a floor harness with full power options and installed it myself. Until my part came in I just went to a junk yard and cut off a good plug then spliced it into my existing floor harness. Hope this helps. It took me 4 months to figure this problem out!!!
537 views
Usually answered in minutes!
×