Reset passlock on 2004 saturn ion - 2004 Saturn ION

Harvey N Tawatao

• 3854 Answers
• Posted on Jun 22, 2009

SOURCE: 2002 Saturn S-series Passlock needs to be reset

Try this first, it takes about 30 min to do. 30-Minute Learn Procedure 1. Turn ON the ignition, with the engine OFF. 2. Attempt to start the engine, then release the key to ON; the vehicle will not start. 3. Observe the SECURITY tell tale light. After approximately 10 minutes, the light will turn OFF. 4. Turn OFF the ignition switch, and wait 5 seconds. 5. Repeat steps 1 through 4 - two more times - for a total of 3 cycles of 10 minutes. 3x10 = 30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch turn from OFF to CRANK Important: Turn the Ignition Switch OFF. The vehicle learns the Passlock Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle. 6. Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password. 7. With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles. Without a scan tool you may have momentary starter interruptions while history clears itself. Good luck and hope this helps, keep me posted, be glad to help 

SOURCE: what are the symbols are on the dashboard of Saturn Ion 1

try www.edmonds.com for owners manuals online

SOURCE: 2004 Saturn Ion transmission

It should be on the drivers side and it looks like the oil dipstick. Usually the top of the handle is shaped like a " T ". Most of the time it will be yellow and say trans on it. It may be lower than the oil dipstick. Good luck.

SOURCE: replacing struts on a 2004 Saturn Ion

i just got a quote from meinke for front struts replaced for just over 500.00

SOURCE: 2004 Saturn Ion blinker problem!

Usually when the turnsignal blinks rapid this is a indicator that the turn signal bulbs is blown, you will need to check both the front and rear signal to see which is not working, and then change the blown bulb or bulbs.