Question about 1999 Toyota Camry

1 Answer

Error code 33 - 1999 Toyota Camry

Posted by tdhogan on


1 Answer

Ranu Nyenye

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 241 Answers

It has no error code for Toyota 33
Recheck the error code if it is appear either of the ff. error code.
P0333 = Knock Sensor 2 Circuit High Input (Bank 2)
P0033 = Turbo Charger Bypass Valve Control Circuit

Posted on May 10, 2012


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Error code mean

23 - Vehicle Speed Sensor
33 - Air Injection Reactor Switch Solenoid

May 22, 2013 | Dodge Spirit Cars & Trucks

1 Answer

The codes are 33 25 5and don't know what they are can you help

33 is a/c clutch curcuit, 25 is idle air control motor curcuits, target idle not reached (+/- 200),vacuum leak found
A code of "55" represents end of error codes. If this is all you get then no error codes are stored in the computer. This is the normal condition. sorry there is no code 5, have a good day !!

Mar 16, 2011 | 1993 Dodge Ram 250

1 Answer

I have a problem with my toyota rav4 1996 the check engine light is on it gives me on the scanner the error code 33. Any help will be appreciated. Regards

A code 33 should be fir the MAP (Manifild Absolute Pressure) Sensor. The most common problem is cracked or broken vacumn lines. Check them first. May have to change MAP Sensor which is a simple job

May 11, 2010 | 1996 Toyota RAV4

1 Answer

Error code 33 on a 1988 dodge pick up

code 33 is the a/c clutch relay will be an open or shorted condition detected in the a/c clutch relay circuit. hop this will help!!!!!

Apr 08, 2010 | 1988 Dodge D-Series Pickups

1 Answer

I just did a code scan on my 1992 Chevy Cavalier RS 6-cylinder and the codes that came back were 32 and 33. What do they mean?

DTC - 32 EGR system failure
DTC - 33 MAP sensor circuit error (signal high indicating low vacuum)

The EGR failure is causing the DTC 33 code to show up. Check the vacuum lines to the EGR valve.

Good luck and keep me posted

Nov 19, 2009 | 1992 Chevrolet Cavalier

1 Answer

Please help! I have a 1992 Plymouth Grand Voyager, code 33

first try to dicconect batery for one minute. this will reset (erase) foult code. do test drive and check error codes again (within 5 sec switch ignition key on-off, on-off, on. count mil flashes, write it down on paper. no 12 and 55 (end) are normal. everithing betwin are errors. if error 33 presist there is something wrong with AC reley or wiring.

Sep 02, 2009 | 1992 Plymouth Voyager

1 Answer

Eror 33

this code u speak of must display on radio. diconnect battery for 10 min and reconnect if it does not correct problem remove radio completely and wait approx 10 then reinstall

Aug 25, 2009 | 2000 Honda Odyssey

1 Answer

1988 Dodge Aries K 2.5L Engine Trouble and codes

Trouble Code 14 indicates that the Coolant Temperature Sensor (CTS) is reporting abnormally high readings. CTS is used to control fuel mixture, timing, idle speed, TCC and EGR operations among others. The thermistor used has a low resistance when hot, rising as the coolant cools. This error then, indicates a very low resistance in the CTS circuit.
Trouble Code 15 indicates that the Coolant Temperature Sensor (CTS) is reporting abnormally low readings. CTS is used to control fuel mixture, timing, idle speed, TCC and EGR operation, among others. The thermistor used has a high resistance when cold, lowering as the coolant warms. This error then, indicates a very high resistance in the CTS circuit.
Trouble Code 33 indicates that the Mass Air Flow (MAF) sensor is reporting more air is entering the engine than makes sense based on RPM and TPS. The MAF sensor produces a frequency output; around 30 Hz at idle to 150 Hz under acceleration. The frequency varies proportionally to airflow. The ECM monitors the frequency and thus determines airflow into the engine. Typical idle MAF is 5 to 7 grams per second.

Mar 30, 2009 | 1988 Dodge Aries

Not finding what you are looking for?
1999 Toyota Camry Logo

349 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides