MERCEDES 320 CLS SRS LIGHT COMES ON WIPER MOTER STOPS, HEADLIGHTS WILL NOT SWITCH OFF

SOURCE: e320 reset SRS

Hi, Joe here to help,
Without going to a dealer, you need to get a scan tool to reset the srs light. Go to an Autozone store, They will scan it and reset it free of charge.

SOURCE: srs light on dashboard on mercedes e320 1999

SRS is not DIY. I strongly suggest you go to a reputable repairer an have it scanned and unless you are very competent Auto Tech leave it to them to repair.The SRS lamp is warning you that the Supplimentry Restraint System has a fault and will NOT funtion if you have an accident. Therfore you don't have this as a backup with your seatbelts .There is a good chance that it is the pressure pad in the passengers seat as has been suggested along with loom and module failures.

SOURCE: 1995 Mercedes S 320 won't start. battery is fine

I know on the L.H. (previous fuel injection system) models there was a module called a base module that worked as a big overvoltage relay and powered up all the control units for the engine and drivetrain,they had 4 to 6 10amp. fuses in the top and theywould blow fuses and sometimes fail themselves causing no start conditions. I beleive yours is an H.F.M. system. I used to do roadside and i'm also a mercedes benz tech. The first thing I would try would be to put the car in nuetral and see if it starts. the nuetral safety switches of that era are problomatic. next I would check my brake light fuse in the engine compartment fuse box. That fuse also powers the starter relay-even though it doesn't state that on the fuse schematic. Also to answer your question about a lockout relay-yes there is but they rarely cause a problem. I hope I have been helpful

SOURCE: SRS Airbag sensor light

i have s500 mercedes the srs light stayes on

SOURCE: how to reset airbag for mercedes benz c220 1994

This can not be reset by conventional methods. This must be done through a scan tool. Usually only the dealer scan tool will communicate with the SRS module. If the SRS light is on you have other issues and they must be remedied before the light will go out. There is no way of knowing what the issue is without running codes with the scan tool.