2005 subaru legacy drivers window wont work

Video on youtube How To Install Replace Master Power Window Switch Subaru Outback 00 04... This still a Subaru !

It says the tachometer wire is Yellow/Green, you do not have that listed. You will find it in the list below, it is highlighted..

WIRING INFORMATION 2001 Subaru Legacy

WIREWIRE COLOR LOCATION

12V CONSTANT WIRE WHITE Ignition Harness

12V IGNITION WIRE GREEN Ignition Harness

12V ACCESSORY WIRE YELLOW Ignition Harness

STARTER WIRE WHITE/BLACK Ignition Harness

POWER DOOR LOCK (-) WHITE Harness In Driver's Kick Panel

POWER DOOR UNLOCK (-) GREEN/RED Harness In Driver's Kick Panel

PARKING LIGHTS (+) ORANGE At Light Switch

DOOR TRIGGER (-) PINK/BLACK In White Connector Behind Fuse Box

TRUNK TRIGGER (-) YELLOW/BLUE In White Connector Behind Fuse Box

TRUNK RELEASE (5-wire) LT.GREEN/YELLOW At Motor In Tail Gate

FACTORY ALARM ARM (-) Factory remote only

FACTORY ALARM DISARM (-) Factory remote only

TACHOMETER YELLOW/GREEN At Ignition Coil

BRAKE WIRE (+) WHITE/BLACK At Brake Pedal Switch

HORN TRIGGER (-) RED/GREEN Harness At Steering Column

LEFT FRONT WINDOW UP BLUE/RED At Driver Window Motor Inside Door

LEFT FRONT WINDOW DOWN BLUE At Driver Window Motor Inside Door

RIGHT FRONT WINDOW UP BLUE/RED Harness In Driver's Kick From Driver Door

RIGHT FRONT WINDOW DOWN BLUE Harness In Driver's Kick From Driver Door

LEFT REAR WINDOW UP BLUE/RED Harness In Driver's Kick From Driver Door

LEFT REAR WINDOW DOWN BLUE Harness In Driver's Kick From Driver Door

RIGHT REAR WINDOW UP BLUE/RED Harness In Driver's Kick From Driver Door
RIGHT REAR WINDOW DOWN BLUE Harness In Driver's Kick From Driver Door

The usual cause is the window motor is worn out. The mechanism (aka regulator) joints are also worn for a 2005. The fix is replace the regulator + motor assembly.

If this is a power window, you would have to disconnect the motor to be able to move the window glass.
If you have disconnected the motor and the window glass will not move, look for something stuck in the regulator or the tracks.

im not sure if this will work but i have read in threads that after you have reset computer you have to wind all the windows down on the doors themselves using the drivers door last=)

You just did. Its the master switch. Buy a switch from a large parts store, use a flat tip screwdriver to remove switch then install new switch. This should take you about 20 mins. Super Easy

First try to reset alarm by inserting key in drivers door lock and lock and unlock-if this does not work try tail lock as well.

I have a 92 that did the same. After checking fuses and the relay(located under drivers seat) I discovered that the power windows control module on drivers door was bad. Went to a salvage and bought a used for $40, pulled the door panel, unscrewed and unplugged the old one, put in the used one and everything worked fine. About a week later, the passenger side motor went out and replaced that with a used power window motor. All windows now work fine.

At your local subaru dealer.