Question about 1995 Ford Mustang

1 Answer

Cant get power to fuel shut off or to fuel pump all fues are fine

Engine will spin over has no gas at fuel rail bleeder vavle have turn switch on pump will not run could ccpm have gone out car has sat up for about a year is this what turns fuel pump on and off to run engine? car is a 1995 ford mustang gt 5.0 thanks mark

Posted by mhub72 on

Ad

1 Answer

Marvin

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 85,239 Answers

Replace the fuel pump if the fuel pump cutoff switch and connector checks ok.

Posted on Nov 19, 2008

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you help with my fuel pump problem on my 1999 Honda Passport?


It Is Supposed to do that (the key turns on the relay) is then switched to the on position then the gas gets pumped to the fuel injection rail which in returns gives it gas to start !! then the cps Crank Shaft Positioning Sensor detects the motor is spinning then keeps pumping gas into the fuel rail which in return pumps fuel though the injectors !! which makes internal combustion possible!!(Your Motor Fire On All Cylinders)!! Best,
We Are Here To Help !!

Aug 25, 2017 | Honda Cars & Trucks

2 Answers

87 z28 How to prime and purge the fuel rail


No prime is required. Pump is located in tank.

92z28fuelpump2-s5y3ewsipro5t2ihgvdymka0-3-0.jpg

Jun 26, 2017 | Cars & Trucks

1 Answer

Ran out of gas in 2003 Dodge Durango I see the bleeder on the top of fuel line,are there any others


Not that I'm aware of, if you put gas in your tank the pump should push the gas right up to the bleeder within seconds, If you turn your key to the on position but not to the engine start position and listen real closely, you should hear your fuel pump kick on for about 2 seconds, if you can't hear it, then open you gas cap and put your ear to the filler hole, then have someone turn the key to on, you should be able to hear the pump for about 2 seconds, if you don't then either the fuse, relay, or wiring to the pump, or the pump itself went out. you can also check to see if you have an external filter on your frame rail, it could be clogged now that the truck was run out of gas.
Also what most people don't know is that their fuel pump is cooled by the gas in the tank, when someone runs the gas down so low that the low fuel light comes on, the pump starts getting hot and this actually hurts the pump causing early failure of the pump if this is done repeatedly. Always try to keep at least 1/4 tank of gas so the pump can stay cool. Good Luck

Sep 29, 2016 | Dodge Cars & Trucks

1 Answer

Sat for 3 years running when we stopped driving now it wont restart. chkd fuses, relays, b


Fuel is probably stale. Pump or pump relay might be stuck.

I suggest you check the fuel delivery to the fuel rail. If no delivery the pump isn't working and the supply should be checked and then take the appropriate action depending whether the supply is good or not.

May 30, 2016 | 2001 Cadillac DeVille

1 Answer

I ran out of gas last night put gas in but now it won't turn over


have to bleed the air out of fuel line do this by locating the bleeder vavle on fuel rail have a friend turn the key on but not crank the car just turn key on open bleeder valve for a couple secounds close it have him turn key off do this a few time until you have steady fuel no air close vavle back vehicle should start now be careful fuel is flamable

Dec 04, 2010 | 1986 Chevrolet Astro Cargo

1 Answer

Hello i have a suburban that my husband just ran out of fuel. he has put fuel in it but it will not turn over


if engine turns over & will not crank after putting fuel in it . 1) make sure fuse is good for fuel pump 2)make sure you can hear pump come on (you should hear pump every time u turn key in on position for a second or two . 3) if thes check out on fuel rail u will have schrader vavle push this vavle couple of times to see fuel comes on (turn key on -off each time u push vavle)

Nov 01, 2010 | Chevrolet Suburban 1500 Cars & Trucks

2 Answers

I have a 1997 bmw 328ic standard,,my car only start with starting fluid and when i stop spraying the starting fluid the motor dies out,,,,i also replaced the TPS sensor and the MAF sensor and...


The bank 1 and 2 are your oxygen sensors. Sounds like your fuel regulator isn't working, or either you're not getting gas pumped from the fuel pump. Turn your car on (not running) have someone to listen for the fuel pump to kick on. Or you can disconnect the line going to the fuel rail and turn the switch on and you will see gas come out if the pump is working.

Feb 25, 2010 | 1997 BMW 328

2 Answers

How do i know if the fuel pump is bad


theres a fuel pressure test port on the fuel injection rail on top of engine left side that looks kinda like a bike tire valve with a black cap on it with the right pressure tester it should read 45 to 55 psi while cranking engine.

Jan 17, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Engine turns over but seems like not getting gas to engine


Disconnect the fuel line at the fuel rail, crank for a second if it doesn't have a bleeder valve. (looks like valve on tire) If no gas comes, change fuel filter, and check fuel pump while down there.

Dec 28, 2009 | 2003 Nissan Altima

1 Answer

My brand new lift pump wont lift


Is it running contant, or for 3 seconds with key on engine off. If its constant no pressure is being delivered. You may just have a bad new fuel pump. Very common for aftermarket pumps to not work correctly. Did you open the line to see if its pumping before the fuel rail or push the bleeder if you have one on the rail. Open the gas cap and listen when someone cycles the key

Jul 17, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
1995 Ford Mustang Logo

287 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Mike

Level 3 Expert

4369 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...