Question about Audi A8
Posted by Anonymous on
relatively easy. just weave the belt over, under and around the pulleys the way its show on the belt patter on the label on the radiator., or make note before pukking off old one. Good luck. Watch the fingers!
Posted on Jun 08, 2009
SOURCE: water leaking in my audi a8
There should be a drain hole or tube that leads out of the car. Find it and clean it out. (wet/dry shop vac?)
Don't poke too sharp of things into it, or you might damage something, though.
Posted on May 09, 2009
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can pull back the weather seal and disconnect the linkage and remove the bolts securing the outer door handle
Posted on Oct 06, 2009
If it's anything like the six cylinder engines from Audi, which I'm very familiar with, and from what I remember of the V8, you have a timing belt that drives the water pump, crank, and exhaust cams, and also includes a tensioner and an idler roller. The timing chains come into play in the cylinder heads. What Audi did was to only drive the exhaust cams off of the crank, using the timing belt, and inside each cylinder head there is a timing chain assembly that is used to drive the intake cams off the exhaust cams. On a periodic service (like the timing service) you only need to do the timing belt. The timing chains are only replaced if the tensioners fail - you'll know this by a diesel-like clatter from the cylinder heads. Failure of the chain drive assemblies is very rare, which is good because they're incredibly expensive (on the V6 engines they're upwards of $700 each). If you're doing this job because it's due based on mileage, don't touch the timing chains in the cylinder heads - only change the timing belt, tensioner roller, relay arm, hydraulic tensioner, idler pulley, water pump, and serpentine belt. You can leave the chains alone.
Posted on Dec 01, 2009
SOURCE: how remove fuel pump audi a8 4.2
check in the trunk ,remove the carpeting and you should find a round access cover remove all the screws and the fuel tank will be visible. now ther will be a large plastic nut you have to unscrew it to get to fuel pump. fuel pump is in the tank. i would first make sure the fuel pump relay is good.
Posted on Jan 12, 2010
Tips for a great answer:
Mar 08, 2014 | 1998 Audi A8
Nov 24, 2013 | 1996 Audi A6
Mar 04, 2012 | Cars & Trucks
Jul 17, 2011 | 1999 Audi A8
Apr 27, 2011 | 2004 Audi A8
Apr 22, 2010 | 1998 Audi A8
Jan 26, 2010 | 2000 Audi A8
Jan 12, 2010 | 1998 Audi A8
76 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: