Car alarm goeoss car will not start

you can get the key to override alarm by just turning key to ON position and leave it that way for 1-3 minutes alarm will slow down and beep a few times then silent. turn key off wait 5 seconds then start engine

Yes. After market remote start kits don't care about keyless entry or alarm systems. You will get a separate key fob to operate the remote starter.

I would return it to the installer

My 2012 Hyundai Elantra Wont Start - CarGurus

www.cargurus.com > Questions > Hyundai > Elantra

CarGurusJul 30, 2013 - My 2012 hyundai Elantra GLS would not start this morning. ... I hit my door unlock on mt Key fab and the doors unlocked fromt here I proceeded start my car.... it and it wont turn over just makes a light click. not like a battery issue. .... But if Istart from the zero position on the starter it doesn't start on the first try ...

No horn / No lights when I lock my car - Hyundai Genesis ...

www.gencoupe.com/.../244433-no-horn-no-lights-when-i-lock-my-car.h...

Mar 30, 2014 - 16 posts - ‎8 authors
I do not know what could have caused this but when i lock my car... ... lock yourdoors with your key fob(might have to hit the lock button twice) ... The alarm/horn should start beeping. ... 2010 Hyundai Genesis Coupe 2.0T R-spec in Karussel White.... My lights flash when I lock it, but the horn doesn't sound.

2013 Hyundai Elantra Engine Won't Turnover, Won't Start ...

www.carcomplaints.com/.../Elantra/.../engine_wont_turnover_wont_start...

The 2013 Hyundai Elantra has 19 complaints for engine won't turnover, won't ...

The 'Keyless Entry & Burglar Alarm System" is activated. You must 'Disarm' the system using the Keyless Entry Remove (Key Fob) to "Reset" the system. The reason the engine won't start is due to the burglar alarm - it has a "Starter Kill" circuit which is activated when the alarm is activated. The alarm must be DEactivated to DEactivate the 'Starter Kill' circuit.
Another way to start the engine is to get in the car, put the key in the ignition and turn it to 'ON" and wait 3 to 5 minutes until the emergency flashers stop/turn off. Afterward, you should be able to start the engine. NOTE: This does NOT reset the burglar alarm. It will go off again when you enter the vehicle without using the remote/key fob.

you willhave to get a new fob from the manufactures as the fob is coded for that car

their is no doubt some way to reset it by turning the key so many times left and right ?? but try this ,and that put key in drivers side lock and lock and open three times slowly then open door on last attempt and try to start within 15 secs of opening the door lock ,also try the spare key in case the chip has fallen out of the key ??

There is NO kill switch on the 2000 Elantra... HOWEVER, there is a thing called the Key Fob (keyless remote entry system). There is, however, a system in place called the 'starter kill' circuit and it is activated when the burglar alarm goes off.... it's called the burglar alarm relay and it is activated to prevent the engine starter system from being used. There are three ways to get the engine started in such a circumstance... 1. use the key fob to 'disarm' the system... 2. put the key in the ignition and turn it to the 'RUN" position and wait until the alarm stops (horn stops beeping and the parking lights stop flashing), then the engine will start.... 3. pull the starter relay from the UnderHood junction box and bypass the starter circuit (key in ignition and in the 'RUN' position), jumper the starter solenoid circuit to energize the solenoid to start cranking the engine -- it should start then.

change the battery's in the key fob

Hi, i had this problem with my 96 model.. i let the battery go flat, then recharged it.

Although disconnecting the battery my work.

Assuming that the batteries dont need replacing in the fobs.