Question about 2004 Jaguar X-Type
Posted by Anonymous on
SOURCE: 1998 xj8 jaguar
I had this exact same problem and the cable was broken. There is a way to get it open by going through the wheel well. Let me know if this is still an issue for you and I can walk you through it. Thanks!
Posted on May 06, 2009
Homelink Garage Door Opener Programming Procedure:
The procedure described below was successfully applied to a 2005 Jaguar S-Type.
To begin with, several attempts were made using the programming instructions contained in my Jaguar’s owner’s manual. Though the procedure described in the owner’s manual was straight-forward and understandable, I was unsuccessful in getting the vehicle’s remote to make my garage door opener function. The particular garage door openers I have are both made by Genie. Both openers utilize the “Rolling Code” feature.
To begin with, be sure to clear previous codes on your Jaguar’s garage door opener by first turning (rotating) the ignition key to the “I” position (first notch). Next, simultaneously hold button 1 (left most button) and button 3 (right most button) down until the middle button’s red light changes from continuous on to a rapid flash. This process takes approximately 20-25 seconds. What follows is a two part process. In the first part, get your Genie portable remote and hold it near (approximately 3 inches away from) your Jaguar’s garage door opener console buttons. Choose which button on your Jaguar’s remote you wish to dedicate to your Genie door opener and simultaneously press and hold your Genie opener button and your Jaguar’s opener button. The red light on your Jaguar’s center button (button #2) will light up and within 1-2 seconds will begin to flash rapidly. You have just completed part 1 of the two part process.
Part two: Now it is time to utilize the “Learn” function on your Genie garage door opener. Press the “Learn” button on your Genie garage door opener. The red LED adjacent to the “Learn” button will begin to flash. You now have 30 seconds in which to program your Jaguar’s opener button. Using the same button you just used in the “part 1” procedure, press and hold the same button for several seconds. As before, your Jaguar’s red light in the middle button will light up and within 1-2 seconds, it will flash rapidly. Release the button you are programming. Now, here is the key piece of information! Once again, press and hold that same button. Once again, the center button’s red light will flash rapidly. Release your newly programmed button. This procedure proved successful in my application. Here is what has just happened. The first time you pressed your Jaguar’s remote button tells the Genie opener that it exists and that it is a viable candidate for making your life easier (opening the damn door). The second time you press your Jaguar’s remote button confirms to the Genie’s rolling code that your Jaguar’s signal is legitimate and is to be trusted from then on.
Posted on Dec 23, 2009
If your bonnet will not release, there is a rubber plug inside fender located up in
the wheel well under the latch. Remove the plug, stick a screwdriver up and pry the latch
back. The hood / bonnet will open.
Posted on Mar 01, 2010
Tips for a great answer:
Aug 15, 2014 | 2004 Jaguar XJ
Aug 15, 2014 | Jaguar XJ8 Cars & Trucks
Aug 15, 2014 | 2004 Jaguar XJ
Jul 23, 2017 | Jaguar XJ8 Cars & Trucks
Jan 04, 2011 | 2004 Jaguar X-Type
Dec 22, 2010 | 2004 Jaguar X-Type
Jan 16, 2009 | 2006 Jaguar XJ8
1,212 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: