AUTO 4 CYL.
SOURCE: 2002 nissian frontier tailgate is stuck
First thing: Try using the key to move to the locked and then to the unlocked position. If this works, open the tailgate... This also pretty much tells you what the root cause problem is, which is a pressed-in plastic post working its way out (see below).
If no bedliner, just remove metal plate inside tailgate and actuate by hand inside to open. If bedliner, first use a small screwdriver to carefully (don't scratch paint) push in latches at either side of tailgate to open/lower tailgate (if locking/unlocking as above did not work to lower gate and gain access). Next, use two blade screwdrivers to pry out the "buttons" that hold the ends of the tailgate liner where they wrap around the sides, then remove bedliner piece and metal plate, etc.
Once you have access to inside of tailgate, you will see how the mechanism works by pulling up and down on the handle while observing. You will probably find that the slide mechism that locks and unlocks the mechanism has been allowed to move such that it cannot unlock/allow movement of the latching mechanism. This is usually the result of the pressed in plastic anchor being worn/loose. I had some success with cleaning thoroughly with alcohol or brake cleaner, allowing to dry and then using super glue to hold it firmly in all the way. Still have to hold handle up when closing gate and keep key on hand to unlock every time opening, but it was a free repair...
SOURCE: Odometer Repair on a 1996 Nissan Pick-up XE
The teeth on the ODO gear are most likely stripped. Seen this a hundred times. Dealer- only repair unless you buy a used speedo head.
Nissan Scope Technician- 10 years with Nissan
SOURCE: 1998 Nissan Frontier Serice Engine Soon Light Problems
Auto zones computer **** not trying to be rude but Im not to fond of there $99 diag tool. Anyways have you tried the dealer, to see if maybe your light may just be a computer glitch or doubtly a maint. light going on and off. Its to bad its not reading it as a hard code. but you could go buy a repaire book and see if it can tell you how to use the OBD II to make the codes flash when the light is on. just a thought for you.
SOURCE: Belts squeal on 1998 Nissian Frontier
Squeal belts usually mean not enough tension. I have had problem with persistance squeling in the past, the problem turn out to be cheap aftermarket belt that keep stretching and wouldn't maintain proper tension, putting brake fluid or any kind of oily liquid on your belt will make it worst not better.
SOURCE: when i have my engine running and i switch on my
i had this problem with my 98 nissian frontier it was 2 things [1] my battery was dead and was not holding charge[2] the belt that runs over the alternator and the radiator fan was really worn i had to replace batter and belt
971 views
Usually answered in minutes!
1998 Nissan Frontier Pickup. The former owner told me that the odometer quit working. A week later the speedometer also quit working. How do I fix.
I was hoping for a DIY fix. ie speedometer cable or sending unit. When I am looking to fix something, I always look for something cheap and or easy. I hope I don't have to take it to the dealer.
×