I am looking for a fuse for my radio unit for 2006 merceds cls 500
SOURCE: My tires were changed on
I have found a lot of times where the tire installer will end up damaging one of the wheel sensors or sometimes not even transferring them over to the new tires when they install them. Double check to see that the TPC wheel sensors are actually there. The valve stem will be grey instead of black. If one got damaged that would also cause the warning to go out. You could try letting the air out of the tires at least more then a 10psi difference and then correct tire pressure right after wards. That is the relearn process to get the sensor to start sending a signal again to the control module. Normally you need the Mercedes Benz "SDS" labtop to activate the relearn in mode, but its worth a shot to try and get the sensors working again with out taking the car into the shop. It may also take driving it a while until the TPC control module re learns the position of the sensors if they weren't installed in the same position before replacing the tires (eg: right/front,left/front etc). You also want to make sure the tire pressure is cold when you reset the light. If you reset the light after driving for a long period of time it will set the threshold at a higher psi due to the tires being hot from driving and then when the car sits for a while and the pressures drop again because there cold it may think a tire is leaking. If the light still won't stay off you might have to take it to a shop to be checked with a 'sds' or a tpc sensor tester.
SOURCE: How do you reset maintenance indicator on a 2006
u can check cls manual or take it to a dealer.
SOURCE: I have a 2006 CLS 500...44,500 miles...due for
service details are given in a booklet that comes along with cls. u'll get all the information there.
SOURCE: how to reset the srs
Before resetting the SRS I would advise to take note of the error. You would need an OBD scan tool for you to get the errors and to reset the SRS.
On the fuse box found on the driver side of the car you should see the port for the OBD tool. Connect the OBD tool. Turn the key to the 'Run' position (the one before 'start'). List down the codes and make necessary repairs with the shop. This also resets the SRS if you wait for the light to go off before disconnecting the OBD scan tool.
SOURCE: what is the meaning OBD to reset SRS for CLS 500
You need a on board diagnostic scanner plugged in to locate fault
SRS is safety restraint system, fault is usually seat belt sensor
A good local auto electrician will locate the problem
Main dealer will cost a lot of money
Good luck Barry
Testimonial: "thanx"
501 views
Usually answered in minutes!
×