Question about 1995 Cadillac DeVille
1995 caddy deville 4.9L ac compressor BYPASS BELT routing diagram
Posted by Anonymous on
Below is a guide to troubleshoot and check system function. This can be done by most folks.
Look at the front of the ac compressor and have someone turn on the ac from inside the car. The front of the pulley(clutch) will spin when turned on.
If it does not spin, the low pressure switch (LPS) is not satisfied. Meaning there is not enough freon in the system to operate the system. Means low freon capicity because of a leak.
The LPS can be jumpered to cause the compressor to run (clutch to engaged) which will draw the freon in the system.
The LPS is usually a two wire sensor on the suction of the compressor. (between evaporator and compressor) Unplug the sensor and install a jumper, this will engage the clutch. Connect a new can of freon
and fill to system capacity.
The capacity of the ac system will be on a label under the hood, do not overfill. Probably about 2 lbs. Local parts stores (Auto Zone and Advance) will have freon with stop leak. This may help the leak. They also make a freon with a UV dye. I always add a single can with dye so that if stop leak does not work I can find the leak in the future.
The system should be filled until suction pressure is about 30 to 38 psi..
Remember the flow for the a/c system is :
1. From the compressor a high pressure (HP) gas goes to the condenser in front of the radiator.
2. From the condenser a HP liquid goes to an expansion device (orifice tube or expansion valve)
3. From expansion device the low pressure gas enters the firewall to the evaporator.
4. From evaporator the low pressure liquid/gas mixture goes through the dryer back to the compressor suction.
Posted on May 29, 2010
It is possible. What you have to do is gat a belt for a vehicle that has the same engine as your car but with out A/C. It will have to be a Chevy or some other GM brand other than Cadillac. You cannot get a Caddy without A/C. I would go to a junk yard and look under the hood of a few cars. Some times even though the engines are the same the acessories may be in different places. When you find something with the same engine and acessories in the same place and no A/C just get a new belt for that car and put it on yours. You may have to remove your A/C compressor to make this work. Good Luck.
Posted on Jul 21, 2009
The lines should be differant sizes.. Did you check it? Ther should be a diagram on the cover over your radiator showing you the set up.. Hope this helps..
Posted on Aug 26, 2009
To avoid confusion, remove and tag the spark plug wires one at a time, for replacement.
If a distributor is not keyed for installation with only one orientation, it could have been removed previously and rewired. The resultant wiring would hold the correct firing order, but could change the relative placement of the plug towers in relation to the engine. For this reason it is imperative that you label all wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations. If the current wiring does not match, make notes in your book to reflect how your engine is wired.
4.5L and 4.9L EnginesEngine Firing Order: 1-8-4-3-6-5-7-2 Distributor Rotation: Counterclockwise
Hope helped with this (remember rated this help) Good luck.
Posted on Nov 10, 2009
Tips for a great answer:
Jan 10, 2016 | Chevrolet Cars & Trucks
Jul 15, 2015 | AC Cars & Trucks
Nov 23, 2012 | 1995 Cadillac DeVille
Sep 03, 2012 | Hyundai Santa Fe Cars & Trucks
Jul 26, 2011 | 1991 Chevrolet Cavalier
Mar 27, 2011 | 1994 Cadillac DeVille
Oct 27, 2010 | Mercury Grand Marquis Cars & Trucks
Dec 18, 2009 | 1994 Cadillac DeVille
Jul 21, 2009 | Cadillac DeVille Cars & Trucks
Feb 06, 2009 | 1993 Chevrolet G20
413 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: