Question about Peugeot 206
Fuel gauge on starting is fine then anything between 5 and 60 minutes drops to zero. If restarting is fine till the same thing repeats it self but not always.
Posted by Anonymous on
put your voltmeter on the little cable that goes to the starter and check the volts there will turning the key to the start position if you have power ...yes its the starter...if you dont then it could be the starter relay
Posted on Dec 31, 2008
It sounds like your thermostat has gone bad and sticking close, Replace the Thermostat and Antifreeze. When replacing the thermostat, buy a fail safe thermostat so you will not have a overheating problem when the thermostat fails. Good luck and hope this helps. Keep me posted, be glad to help.
Posted on Jun 22, 2009
In my opinion cut off problem occurs if engine is not getting sufficient fuel and/or air. Clean the air filter, turbo filter and fuel filter. Check the continuity of diesel flow from filter to hdi pump. If you haven't found any problem there then the possibily the hdi pump and injectors section needs to be checked. If the car has done more than 100000 miles then clean inlet and outlet manifolds including check of turbo and EGR valve. Do everything whatever possible before you take your car to garage. If there is no luck then let your car diagnosed and check any error code recorded by ecu.
Posted on Oct 13, 2009
Probably a defect lambdasonde or inlet pressure sensor (MAP sensor) it will show many different errors on the test readout ex: inlet manifold pressure, knock sensor, lambda value wrong, idle speed out of range, etc.
read out the faults,after delete the readout, then drive one day, read faults out again , compare the results, and change the components from test
Posted on Nov 05, 2009
Tips for a great answer:
Jun 23, 2015 | 2005 Peugeot 206 1.1
Apr 25, 2014 | 2001 Peugeot 206 1.6
Apr 08, 2013 | Cars & Trucks
Feb 28, 2011 | Peugeot 405 Cars & Trucks
Mar 06, 2010 | 2005 Peugeot 405
Feb 19, 2010 | 1991 Peugeot 405
May 24, 2009 | 1991 Peugeot 405
77 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: