2007 Dodge Charger SE Logo

Related Topics:

Glenda Jackson Posted on Apr 13, 2012

Engine code P0660 on Dodge Charger

I have a 2007 Dodge Charger and the check engine light came on....I had it hooked up to a computer and it is giving me a code P0660....is this something I should take to the dealership for or is this something that can be fixed at home???

2 Answers

Michael Lindsey

Level 1:

An expert who has achieved level 1.

  • Contributor 1 Answer
  • Posted on Jun 12, 2022
Michael Lindsey
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Jun 12, 2022
Answers
1
Questions
0
Helped
2428
Points
4

2007 dodge charger where is the fuse located for the intake Tuning valve Control circuit open Bank one code p0660

mike

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Jul 23, 2015
mike
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Jul 23, 2015
Answers
1
Questions
0
Helped
2428
Points
1

The code means intake manifold control valve not any of these answers here.

Ad

5 Related Answers

Anonymous

  • 85 Answers
  • Posted on Jul 02, 2008

SOURCE: 2004 Dodge Caravan check engine light is on

P0406 is egr positon high replace the egr valve and se if the light comes back on for the miss fire on cylinder 4

Ad

Anonymous

  • 512 Answers
  • Posted on Jan 25, 2009

SOURCE: 2006 dodge ram 4.7 engine light on

it can be reached from the top of the engine. its just a real pain to do. two 10mm hold it to the drivers side head.

Anonymous

  • 350 Answers
  • Posted on Feb 28, 2009

SOURCE: Check engine light

RE: Check Engine Light

The check engine light may come on for several reasons
.
It is not necessary to worry as it may be as simple as putting the gas cap on without fully clicking it shut!. If this is the case it will go away by itself in about a week at most!

You can take your car to an auto parts store to have them run a diagnostic (Some will do this for free).

If your car is running fine, re-tighten the gas cap, give it a week or have it diagnosed if you still feel uncomfortable with it.

jackiaria

ZZZoom

  • 151 Answers
  • Posted on May 10, 2009

SOURCE: check engine light on code

This trouble code is Evap Purge System Performance fault. 1) Check for a loose or missing fuel cap. 2) Check for a damaged or missing fuel cap seal. Recheck for other trouble codes. This fault wont cause the stumblering problem. It turns on the MIL lamp to say there leak in the EVAP system.

Anonymous

  • 8 Answers
  • Posted on Oct 28, 2009

SOURCE: 2002 Dodge Durango 4.7L V8 Check Engine Codes

1st try and search for a vaccum leak, due to the fact that these vehicles have had some bad problems with the length of wires and hoses, if there is a vaccum leak in the vehicle somewhere that will trigger other malfunctions in your vehicle. Using a can of starting fluid or Brake cleaner spray lightly spray around our engine til you hear the motor rev-up and the spot you have sprayed will determine where your vaccum leak will be. And then check under your distributor cap for any moisture be sure to take a rag and wipe and residue off. Also check the firing order on your distributor.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2007 Dodge Charger SXT 3.5 is in limp mode with stored codes P1004,P0016,P0404 and no check engine light on.

1004 means you had a disconnection or flat battery.
0016 crankshaft position sensor has no/poor signals.
0404 check the EGR sensor.
Probably a bad connection in the engine loom.
Have fun finding it ??
0helpful
2answers

My Dodge Journey 2010 has engine light code of p0660. How long can I drive with this light on without damage..it is not flashing just solid.

https://www.allpar.com/forums/threads/po660-trouble-code.155523/

Here is a link to a forum discussing this very issue on your vehicle.

0helpful
1answer

Why does my dodge charge engine shut down and oil light came on.

The oil light comes on when the car shuts off because there is no oil pressure. Make sure it has oil in it. If so take the car and get the codes pulled off the obd computer.
0helpful
1answer

Check engine / fluids lights

Have you checked all of your fluid levels? on the check engine I would have it hooked up to a computer to give you a code. it could just be your fluid levels. it is possible for it to be interconnected. good luck
1helpful
1answer

I have a 2007 dogde charger and my check engine light is on. I get codes P1005, P0158, P0157 and P0128. I am not sure what these mean or what to do about them can anyone help?

P1005 is model specific, Dodge is a problem with the manifold tuning valve.
Code 158 and 157 are for a problem with the O2 sensor for bank two after the catalytic converter.
Code 128 is for a problem with the thermostat or the engine is not reaching normal temp.
The O2 sensor codes could be caused from the manifold valve or they could be caused by a faulty O2 sensor.
I would start with the coolant temp problem and work back.
1helpful
1answer

07 dodge charger fault codepo660

P0660 DODGE Description

The Intake Manifold Tuning Valve (IMTV) system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is more or less than an the expected calibrated range

Symptoms- Engine Light ON (or Service Engine Soon Warning Light) Possible Causes- IMTV signal circuit open, shorted to power or ground.
- Damaged IMTV actuator.
- Damaged ECM.
When is the code detected?Dual plane intake system-Control solenoid failure
0helpful
1answer

I have a 2007 Dodge Charger Law Enforcement edition with the 5.7 Hemi engine. My vehicles ABS light, emergency brake light, yellow engine light, are on. My speedometer will not work and the vehicle will...

This code does not match any codes for that year, this is not a code, something is wrong if the scan tool is giving you a 5307, the code should be something like a poxxxx or pxxxx or it can be a U code, uxxxx or a bxxxx code, the almost sounds like a bad speed sensor as the ****** doesnt shift and the abs and brake light is on, i would start by having the speed sensor checked out. good day.
0helpful
1answer

My engine light came on lastnight. my dodge charger is using gas way to fast and stalling a little. what is wrong.. im scared to drive it

Alot thing could be there; first I sugges scanned the PCM (computer) to know excalty what "engine fault code" is stored there; if your engine light turn on, them you have one or more codes there. With this number code, send us and we will give additional details.

Keep in touch.
0helpful
1answer

Engine skipping

well i had a 98 dodge neon that seems like it did the same and it said engine misfire and all i did was due a tune up change spark plugs and wires.
Not finding what you are looking for?

2,438 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...