Question about 2006 Honda Accord 3.0
Have a 2006 Honda Accord sedan have had new tires on front, alignment and have replaced rotors on back. Car shakes when going 70 mph. Can you provide me with a solution?
Posted by Anonymous on
SOURCE: 2003 accord shaking
hmm.. im just taking a shot in the dark but when my car did this i needed new wheel bushings. It would shake and sound louder than usual.. not crazy, but a little louder. Anyhow, I changed my bushings and the shake was gone! :) justa suggestion..
Posted on Mar 17, 2009
SOURCE: taking off front rotors
the easiest way is to take off the knuckle loosen the four wheel bearing bolts on the backside of the knuckle and leaving the socket on each bolt use an impact hammer to drive the bearing out then rotate the rotor 1/4 turn and it should pull off. . . you might have to clean up the rust on the bearing with a grinder so the rotor will come off... do NOT take the bearing apart you do not need to. many shops will do this but it is not needed and ruins the bearing as it is a sealed unit not designed to come apart. ( to take the knuckle out take off the caliper and undo the axle nut, top and bottom ball joint and the tie rod end)
Posted on May 24, 2009
the tires make steady noise , check the wheel bearing as noises get high and low at the same speed , and i also would check for diff if it's 4wd.
Posted on Jul 25, 2009
Tips for a great answer:
Sep 25, 2016 | Honda Accord Cars & Trucks
May 20, 2014 | 2006 Honda Pilot
Apr 17, 2013 | 2004 Honda Accord Sedan
Aug 20, 2012 | 2006 Nissan Quest
Jul 14, 2012 | 2006 Chrysler Pacifica Touring
Jul 12, 2010 | Cars & Trucks
Apr 14, 2010 | 1992 Honda Accord
143 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: