Question about 1991 Jeep Wrangler

Open Question

1991 Jeep wrangler Yj clutch cable problem - 1991 Jeep Wrangler

Posted by sepsully06 on

Ad

5 Related Answers

emissionwiz

Marvin

  • 85239 Answers

SOURCE: 1991 jeep wrangler clutch

U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.



1abd4ec.jpg

Posted on May 13, 2009

Ad

Anonymous

  • 4 Answers

SOURCE: Jeep wrangler Fuse box

i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck

Posted on Jun 30, 2008

Ad

Anonymous

SOURCE: 1991 JEEP YJ WRANGLER CLUTCH

Check clutch fluid. Also check for clutch fluid leaks. I just found out that I had the same problem.

It is a leak of clutch fluid (brake fluid) under the dashboard. My mechanic says it's a simple fix.

Posted on Aug 06, 2008

Anonymous

  • 1 Answer

SOURCE: 1992 YJ clutch fluid disapears.

It's probably your slave cylinder. On my '89 it was located in the clutch housing. You have to take the tranny off to get access to it. This is probably why the fluid is "disappearing." I'd suggest changing the clutch while you're at. They sell kits for this at auto parts stores.

Posted on Feb 23, 2009

Anonymous

  • 1 Answer

SOURCE: Looking for Service Repair Manual Jeep Wrangler YJ

i have a 1988 jeep wrangler 6cyl with 5 speed transmission. I was shifting the jeep and it got stuck in third gear. We opened it up and saw that the linkage is aligned and everything is in place. I dont know what is wrong and what to do next. please help ....

Posted on Sep 08, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Free belt diagrams


http://serpentinebelthq.com/1991-jeep-wrangler-yj-4-0l-serpentine-belt-diagram/ her is a link for you to a diagram. I hope this helps

Jul 08, 2014 | 1991 Jeep Wrangler

1 Answer

91 jeep wrangler YJ shifting problems


do you mean it wont go into gear ? if so what gears ? it could be the clutch going out , if the pedal is soft or easy to push down than it probably needs a clutch. next time it wont go into gear try pumping the clutch or putting it from 2nd to 1st or what ever gear it has problems with

Dec 18, 2013 | Cars & Trucks

1 Answer

Jeep YJ stalls while clutch is depressed


thrust bearings are bad and the flywheel is moving out of range of the crankshaft sensor, or the crankshaft sensor is sitting too close to the flywheel.

Mar 12, 2013 | 1998 Jeep Wrangler

1 Answer

Where do you bleed the clutch at on a 1997 jeep wrangler what is the location of it


This all depends if this is a hydraulic clutch or if its cable operated, you can only bleed hydraulic clutches, to bleed it you would bleed at the ******, you will see the bleeder screw on the slave cylinder that operates the clutch fork.

Sep 03, 2011 | 1991 Jeep Wrangler

1 Answer

Where is the clutch resevoir for a 94 jeep wrangler yj


if it is on the firewall then yes it is the clutch fluid resovior.

Sep 02, 2009 | 1994 Jeep Wrangler

3 Answers

Looking for Service Repair Manual Jeep Wrangler YJ


i have a 1988 jeep wrangler 6cyl with 5 speed transmission. I was shifting the jeep and it got stuck in third gear. We opened it up and saw that the linkage is aligned and everything is in place. I dont know what is wrong and what to do next. please help ....

Jul 10, 2009 | 1992 Jeep Wrangler

2 Answers

1992 YJ clutch fluid disapears.


check for leak at the push rod for the clutch master under the dash and also the slave cylinder and replact the leaking part

Jan 23, 2009 | 1995 Jeep Wrangler

2 Answers

1993 Wrangler 4.0 Randomly My clutch pedal will not go in.


I can't remember if that year has a clutch master cylinder or not. Check to see if it does, it will be next to the brake master cylinder, and look like a single round silver dollar sized vesle. To the left of your brake master cylinder. check if its bone dry, if so refill it.

if this is not the case and it does not have a master cylinder, you need to check your clutch out.

Dec 03, 2008 | 1991 Jeep Wrangler

1 Answer

Clutch Pedal to Floor


slave cylinder needs replaced

Nov 12, 2008 | 1991 Jeep Wrangler

Not finding what you are looking for?
1991 Jeep Wrangler Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...