Really hard to shift, now wont go into gear
SOURCE: Shifting from 2nd gear
transmission shift solenoid rockauto.com is a cheap place to get an oem part
SOURCE: transmission problems 4 a 94 s-10 blazer
These transmissions are computer controlled, and this sounds like you have electronic problems coupled with mechanical transmission problems. I suggest you consult a transmission specialist to diagnose your problems.
SOURCE: automatic transmission bangs into gear.
sounds like a bad u-joint. when it wears out it will allow play in the drive shaft, causing it to make a bump while shiftinf
SOURCE: hard to shift into first gear
Tighten clutch cable until the car would start to move when the clutch peddle is 50% depressed, Before you do that, with the clutch fully depressed and in 2nd gear, start the car and slowly let off the clutch. You may find that the clutch has to be released virtually all the way before the car moves. It should be at about that 50% I spoke about
SOURCE: my 97 chevy blazer won't shift past 3rd gear
Drop the pan, odds are the shift solenoid is out, its located at the front of the trans on the driver side. I'm sure your check engine light is on that will comment about the timing/shift solenoid being bad. I had the same problem with mine. The solenoid had plastic coming out of the inside. To remove it you'll find a small C clip holding it in, just take a small screw driver and pull the clip out. The part cost me like $36 from my local dealership. And its a longer solenoid. I believe its the 3-2 downshift solenoid. I do have the part number if you need it.
Testimonial: "Thank you so much. I actually thought this was the problem, but i didn't know. Thanks again!! send me the part number"
269 views
Usually answered in minutes!
poured brake fluid in and worked for awhile
×