Question about 2005 Hyundai Accent 1.5

1 Answer

2005 accent tail lights wont shut off

All lights work, but tail lights won't shut off, even with the key out of the ignition. This problem came on suddenly. Parked the car at work, when I got back at the end of the day, the car wouldn't start, battery was dead. After jumping it, car drove fine all the way home. After getting out of the car, I noticed the tail lights were still on. the only way to shut them off is to disconnect the battery. any ideas?

Posted by Anonymous on

Ad

1 Answer

jack layton

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 5,308 Answers

Pull that fuse or pull tail lamp relay, that should kill the lamps till you figure out the problem? You also have left an right tail lamp fuses, underhood fuse box. I don't know if tail lamp relay is faulty? Another concern, see the bottom wire on left of tail lamp relay, that is a ground controlled by the headlamp/multifunction switch, there could be a problem with that wire circuit or the multifunction switch. At the moment, I'm hoping just faulty relay.
2005 accent tail lights wont shut off - tail lamps-0a0efphnw20vwoqbt4llid1t-4-0.jpg

Posted on Jul 10, 2017

Ad

5 Related Answers

Anonymous

  • 566 Answers

SOURCE: with the ignition off, the rear tail lights won't turn off

hiya if the rear lights are remaining on ? with no ignition it will be the brake lights staying on this is easily remendied/ checked by trypulling the brake pedal up by hand and see if lights go off ? if so then you will need to adjust the b/light switch which is positioned adjacent to pedal and can be screwed inwards towards the pedal untill the plunger on switch is pushed into the switch which puts lights off ensure pedal is fully up then adjust switch reconnect the wire/plug and press pedal slightly to ensure b/lights operate ok and then go off with pedal released ? on hyundai the brakelights do not req ignition on to operate hence more likely problem is as above good luck

Posted on Oct 11, 2008

Ad

Anonymous

  • 6 Answers

SOURCE: 99 hyundai accent starts sometimes. not battery

ok when the check engine light comes on that usually indicates a engine malfunction...what you can do is go to your local autozone and they can do an OBDII test for free..my bet says it is the cam or crank sensor.. DO NOT SHUT THE CAR OFF AT AUTOZONE..LOL

Posted on Jan 01, 2009

Anonymous

  • 20 Answers

SOURCE: 2000 hyndai accent, starts hard, wont start when engine gets warm

ask hundai if there is a main relay. These are often the cause of this kind of problem and normally reside under the dash.
This is common in Honda, Accura, toyota and huyndai.
Replace main relay or take it apart and resolder all connections.

Posted on May 08, 2009

william moody

  • 713 Answers

SOURCE: 2002 Hyundai Elantra brake and battery light on and cannot steer

I believe the alternator belt has broken or the alternator it's self has quit working. Open the hood and see if any of the pulleys are missing the belt.

Posted on Sep 25, 2009

dmsr63

Douglas Hansen

  • 2050 Answers

SOURCE: hello i have a 2008 hyundai accent gls. it has

Get it scanned. You should be under warrantee. Otherwise most auto parts stores will do this. Could be as simple as a loose gas cap.

Posted on Oct 01, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car brake lights won t turn off when car is shut down , was working fine before it was towed and now they wont go off. Did the tow person do something as they towed it or is it something in the car? 2007...


It is possible that the brake light connection was damaged during towing... however it isn't likely.

Understanding where the problem happens is critical. You say it happens when the car is "shut down", but is the key out of the ignition? or is the engine just off? it it actually your brake lights? or just the tail lights? some more info would help narrow it down.

Oct 22, 2014 | Cars & Trucks

1 Answer

Car wont start


You need to be very quiet for this test, but try turning the ignition key until dash warning lights are on, but without cranking the engine. Listen for whirring noise from fuel pump in the gas tank. You may even lift out the rear seat base, to pick up any sound as best you can. If you can't hear anything from several attempts then it's likely you have a failed fuel pump. The fuel pump can sometimes suffer damage when running out of fuel.

Oct 30, 2012 | 2005 Hyundai Accent 1.5

1 Answer

2005 Hyundai accent won't start. it turns over but is not starting.


You'll have to figure out if it is a fuel or ignition problem.
Check and see if you are getting spark to the plugs first.
Also re-check the computer for codes and see how many are back.
Trouble codes are suggestions, not solid instructions.

Jun 28, 2012 | 2005 Hyundai Accent

1 Answer

Second Chip key for 2005 Aveo won't work


assuming the 2005 model year stil uses viper security systems...the chip in the key carries a magnetic resistance frequency. if the chip is damaged or corroded the frequency will change and wont engage the igntion. you can either get another key made (about 75 dollars) or bypass the ignition lockout feature.

May 18, 2012 | 2005 Chevrolet Aveo

1 Answer

2005 Blazer key won't turn in the ignition


You may want to try to slightly push / pull your vehicle to take weight / tension off the transmission, which in turn will allow you to turn the steering wheel enough to see if the ignition switch can be turned.

Jun 24, 2017 | 2005 Chevrolet Blazer 4WD

1 Answer

2005 gmc yukon security light on cluster is on


The security light is a visual indication that something in the car's antitheft system is failing. In most GM cars and trucks there is a hidden system that most people are unaware even exists. From the moment you put your key in the ignition, there begins a constant line of communication between your key's security chip or transponder, to the ignition's lock cylinder, and then to the car's TDM. These 3 parts are in CONSTANT communication. If the key is in the ignition, these parts are sending signals to each other. The security light illuminates when that signal gets broken, even just for a second. When the signal breaks, the car goes into antitheft mode. The car thinks its being stolen or hotwired because it is not getting that signal from YOUR specific key. There is where the security light turns on and shuts down your vehicle.
http://vatspasslockpasskeysecurityhelp.yolasite.com/

Dec 24, 2011 | 2005 GMC Yukon

2 Answers

2002 chevy venture not starting, fuel pump not working security light is on. is this the pass lock or maybe something else?


YEP IF YOU SEE SECURITY LIGHT FLASHING YOUR CAR IS IN THEFT SECURITY MODE WHICH WILL SHUT DOWN FUEL SYSTEM. HAVE VECHICLE CODE SCAN PROBLEM IN THE BCM MODULE.IT WILL TURN OFF FUEL IF IGNITION KEY HAS IN CORRECT RESISTANCE OR KEY WORN OUT.MAKE SURE YOU HAVE FACTORY IGNITION KEYS.DONT GO TO HARD WARE STORES GET EXTRA KEYS MADE.BECAUSE IF BCM ECM AND IMMOBILIZER CANT READ KEY CODE RESISTANCE WHICH NOT IN A REGULAR KEY IT WILL SHUT DOWN FUEL SYSTEM AND CAR WILL GO IN THEFT SECURITY MODE.YOUR PROBLEM IS DEALERSHIP FIX.

Aug 20, 2011 | Chevrolet Venture Cars & Trucks

1 Answer

My key wont turn to off in order to remove my key from ignition while in parking


Ignition - Key Stuck In Ignition Switch/Won't Turn Bulletin No.: 06-02-35-005 Date: February 28, 2006 TECHNICAL Subject: Key Stuck in Ignition, Key Will Not Return to Off Position, Shifter Button Won't Release in Park Position (Adjust Shifter Detent Finger) Models: 2002-2005 Chevrolet Monte Carlo Condition Customers may comment on any of the following conditions: - The key is stuck in the ignition cylinder. - They cannot return the key to the off position to remove the key. - The shifter button won't release in the park position. Cause This condition may be caused by the detent finger shifting over time. This may result in mis-alignment and binding of the shift rod on the shift position guide.
WHERE YOUR SHIFTER IS YOU WILL HAVE TO TAKE IT APART ..MAYBE THE RUBBER BOOT IS IT THE WAY,OR THE SHIFT LOCK SELINOID WHENT BAD

Aug 05, 2011 | 2005 Chevrolet Monte Carlo

Not finding what you are looking for?
2005 Hyundai Accent 1.5 Logo

Related Topics:

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...