99 volvo s70 will not start

SOURCE: volvo s70 radio code

You must take the car to a Volvo dealer so they can reference the code from the VIN number. If you call it in, they only assume you stole the radio. Sometimes you have to prove you own the car.

SOURCE: 1999 volvo radio code

To reset the radio you have to leave the key in position one (the radio will come on, but the dash lights are not on) with the radio on for at least two hours. It can take up to four hours to reset.
Make sure the climate control and blower are in the off position to keep the battery from running down. Eventually the radio will say "code". There is a four digit code that is unique to each radio, if you don't have it you must contact the local Volvo dealer and have your VIN code. The VIN code is locate on the far top/right side of the dash, you must be outside the car to see it. It will begin with something like YV1LS...................

When you get this code from the dealer you input the code using the radio preset (1-6 buttons). If the radio says code again that means it is the incorrect radio code. Most likely the radio has been replaced. Then it would be alot easier to take it to the dealer since the radio has to be removed and the serial number taken off the radio chassis unit. Usually most dealers will do it for free if they think you'll come back for services, so just tell them you just bought it and be nice, hopefully it will work.


hope this helps

Ramy de Jesus

• 377 Answers
• Posted on Jun 09, 2009

SOURCE: 1999 volvo s70 will not start sometime after door unlock

Try to check the battery and the alternator and the fuse make sure the battery connector is not loose.

I’m happy to assist further over the phone at https://www.6ya.com/expert/ramy_d9e7ebea3891f482

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

SOURCE: My radio is locked and says off for 1998 s70 volvo need code

got to a Volvo dealer and they will reset it factory default

SOURCE: 99 Volvo S70 code 1618. What needs to be done to

CODE P1618 CABLE FAULT BETWEEN AW 50 Q2 TRANSMISSION CONTROL MODULE.AND MOTRONIC 4.4 ENGINE CONTROL MODULE LAMP LIGHTS.