Question about 1989 Ford Crown Victoria

Open Question

1989 ford crown vic blower motor resistor replacement

Where is the blower motor resistor located in the car?

Posted by Anonymous on

Ad

4 Related Answers

mutthu273

muttaiah thokala

  • 3 Answers

SOURCE: location of blower motor resistor

in china

Posted on Jun 16, 2008


emissionwiz

Marvin

  • 85239 Answers

SOURCE: blower motor resistor

It is under the hood in the heater case (passenger side), the right side of the case near the firewall as you face the engine.

Posted on Sep 02, 2008

Ad
01fordeb

Chris Busby

  • 1033 Answers

SOURCE: 1998 Ford Expedition Fan Blower Resistor Location

It should be located on the blower motor housing under the right side of the dash, it will have wiring connector and 2 screws holding it in.

Posted on Jan 24, 2010

Mike Schneider

  • 245 Answers

SOURCE: the heater blower motor on my 2001 ford crown vic

look for relay or resistor heater box under hood passenger side follow heater hoses 2 two heater box coming out of fire wall

Posted on Jan 25, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 mustang blower motor resistor location
The blower motor resistor can be accessed from below the RH side of the instrument panel.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the 2 blower motor resistor screws.
  1. Remove the blower motor resistor.
  1. To install, reverse the removal procedure.

Feb 21, 2015 | 2005 Ford Mustang V6

3 Answers

2009 cobalt blower motor resistor location
This video will show you where the blower motor resistor is located on your 2009 Chevy Cobalt and how to replace it.


Jul 02, 2011 | 2006 Chevrolet Cobalt

2 Answers

1999MERCURY MOUNTAINEER AC BLOWER ONLY RUNS ON HI SPEED? WHAT TO DO?
blower motor resistor is burnt up
located upsteam in air plenum from blower motor
passenger side compartment at foot
locate motor then you should spot resistor close by

May 09, 2011 | 1999 Mercury Mountaineer

1 Answer

Need to locate the motor blower resistor for my 1999 mercury mountaineer, it has dual air, the resistor for the back is fine but the one in the front is bad and i cannot locate it. Please help.
If you have a manual system, you have a resistor. If electronic, you have a blower motor speed controller. Please rate if this helps.

here is info:

Control System Outputs-Manual A/C
Blower Motor Switch Resistor
The heater blower motor switch resistor has the following features:
  • The assembly is located on the evaporator housing in the engine compartment.
  • Three resistance elements are mounted on the resistor board to provide four blower motor speeds.
  • Depending on the heater blower motor switch position, series resistance is added or bypassed in the blower motor circuit to decrease or increase blower motor speed.
  • An overheating protective device (thermal limiter) will open the resistor coil circuit when the temperature reaches 121°C (250°F) interrupting the blower motor operation in all speeds except HI.
  • The thermal limiter cannot be reset and is not serviceable.
Control System Outputs-EATC
Blower Motor Speed Control
The blower speed control is located on the evaporator housing in the engine compartment.
  • The function of the blower motor speed control is to convert low power signals from the electronic automatic temperature control module to a high current, variable ground feed for the blower motor (18527).
  • The blower motor speed is infinitely variable and is controlled by the electronic automatic temperature control module software.
  • A delay function provides a gradual increase or decrease in blower motor speed under all conditions.

Jan 10, 2011 | 1999 Mercury Mountaineer

3 Answers

Blower motor resistor, where is it located/
It will be up under the dash on the passenger side near the blower motor. It will have 5 or six wires in its connector

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Nov 10, 2010 | 2000 Jeep Grand Cherokee

1 Answer

2005 Kia Sorento only blows hot and cold air on high. Is it a blower motor resistor and if it is where is it located?
If the blower moter only works on hi speed it is the blower motor resistor that is bad. The blower motor resistor is located under the passenger side of the dash next to the blower motor. It is not necessary to remove the blower motor to change the resistor.

May 12, 2009 | 2005 Kia Sorento

1 Answer

Blower motor fuse is located 99 mercury cougar
SECTION 412-04: Control Components 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Blower Motor Resistor Removal
  1. Remove the upper footwell trim panel (passenger side).
    • Remove the pushpins.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the blower motor resistor.
-------------------------------------------------------------------------
f9d16f6.gif

May 06, 2009 | 1999 Mercury Cougar

3 Answers

Lincoln 2000 town car Blower doesn't work at HI-MED-LOW speeds...
it is called blower motor resistor , should be close to blower motor , you will see a plug type connector with two screws , remove the screws and there should be a resistor inside the cover for the motor, swap with new and reassemble

Feb 19, 2009 | 2000 Lincoln Town Car

1 Answer

I have a 1994 325i BMW
hi there see if this picture helps you locate it .

1994 BMW 5 Series Blower Motor Resistor Location BMW Repair:

AC blower motor resistor 325I 1992 E36, blower motor resistor, dial control



riz.

Jan 08, 2009 | 1994 BMW 3 Series

1 Answer

Where is the heater blower motor resistor located
if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor

Dec 06, 2008 | 1999 Mercury Villager

Not finding what you are looking for?

View Most Popular

1989 Crown Victoria

  • Cars & Trucks

Related Question

2005 mustang blower motor resistor location

  • 2005 Ford Mustang V6

Open Questions:

0 Answers

Where is the ecm located in 1989 ford crown vic

Mar 11, 2017 | 1989 Ford Crown Victoria

0 Answers

89 crown victoria 5.0 l efi hesitates,stumbles on acceleration

Feb 27, 2017 | 1989 Ford Crown Victoria

0 Answers

looking for a electrical wiring diagram on a 89 ford crown victoria

Oct 19, 2016 | 1989 Ford Crown Victoria

0 Answers

the dash lights and rear lights do not work on my 1989 ford crown victoria ltd and fuses are okay. what else can it be? What else could be wrong?

Jul 07, 2014 | 1989 Ford Crown Victoria

See all 1989 Ford Crown Victoria Questions

Cars & Trucks Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

3 Answers
2003 crown victoria fuse box diagram

2003 Ford Crown Victoria

3 Answers
Location of EGR valve for 4.6 liter engine

1992 Ford Crown Victoria

1 Answer
FUSE BOX DIAGRAM FOR A 97 CROWN VIC

1997 Ford Crown Victoria

3 Answers
Show me the right fuse

2003 Ford Crown Victoria

1 Answer
How do you remove right rear axle on a 2004 ford crown vic to replace seal on wheel?

2004 Ford Crown Victoria

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14866 Answers

Mike

Level 3 Expert

4372 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...