Question about Cars & Trucks

Open Question

Need wiring diagram for the starter on cub cadet 7000 series, 26 hp diesel

Posted by frank yoch on

Ad

3 Related Answers

Anonymous

  • 24 Answers

SOURCE: need a wiring diagram for

Here it is. Please vote for me and give me a high rating, thank you. It takes time to find these things and I'm giving it to you free. Thanks and good luck.95e7514.gif

Posted on Sep 12, 2010

Testimonial: "very helpful and nice "

Ad
tunde007

Tunde Autos

  • 2382 Answers

SOURCE: 1997 nissan diesel rf8 truck cg52

Hi, you cannot get the wiring diagram of your car in particular free of charge online except you have to purchase them online or get it from any local library near you. You can visit this site to request for it. Click this LINK.............

Posted on Dec 19, 2010

Ad

Jerry Van Sickle

  • 334 Answers

SOURCE: need urgent wiring diagram for

Hello t120triumphb,

I hope this helps.


netvan_99.png




Regards,
netvan

Posted on Apr 17, 2011

Testimonial: "Thanks very much, Really helpful."

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cub cadet zero turn 44"


You can get that from Cub Cadet's website

Dec 06, 2016 | Cars & Trucks

1 Answer

Have a cub cadet gt 2554 and it wont turn over. 23hp kohler


Make sure there are no loose wires to battery or starter.
Check and make sure your battery has over 10.5 volts. This voltage is a shorted battery and if you tried to pump it won't start. The other problem is an open battery which will have a 0.50 Volts but will start with a jump but it will not retain a charge.
Now let's check your starter and try to jump it with a screwdriver.
The reason for this is you might have a bad switch or bad solenoid or bad starter. I hope this was helpful and let me know how you make out.

Jun 16, 2014 | 2003 Mercury Grand Marquis

2 Answers

I need a wiring diagram on the ignition and information to bleed the diesel pump after running out of diesel. I have a 1.7 utility 2001


prime system by switching on the ignition three times for 15 seconds each time.then operate starter maximum 30 seconds. if engine still dont start wait 5 seconds repeat the procedure.if engine does start idle rough run engine fast idle speed for one minute purge air out the lines until engine run smooth.

Oct 03, 2013 | 2001 Opel Corsa 1.7

1 Answer

I need a wiring diagram for a 2001 Chevrolet 3500 Duramax Diesel


We do not have wiring diagrams here. The material is copy protected and not free to share online. You can buy access and download the factroy diagrams here, you can also buy the factory repair manuls used here.

Nov 02, 2012 | Chevrolet Cars & Trucks

1 Answer

2001 BMW x5 Series I need to find the starter and ignition wire


I am sorry but we have no wiring diagrams here at fixya. I am told you can access the wiring diagram for a fee here www.alldatdiy.com

Jul 17, 2012 | Cars & Trucks

1 Answer

1988 Chevy Tahoe Starter going out. Need to replace


Generally starters have 2 or 3 bolts and a thick wire coming from the battery and other miscellaneous connections.

You did not specify a vehicle that was on my list, i.e. 1988 Chevy Tahoe.

However, it may be similar to a Suburban R10:
REMOVAL & INSTALLATION The following is a general procedure for all trucks covered in this manual, and may vary slightly depending on model and series.
  1. Disconnect the negative battery cable at the battery.
  2. Raise and support the vehicle.
  3. Disconnect and tag all wires at the solenoid terminal. NOTE: Reinstall all nuts as soon as they are removed, since the thread sizes are different.
  4. Remove the front bracket from the starter and the mounting bolts. On engines with a solenoid heat shield, remove the front bracket upper bolt and detach the bracket from the starter. Fig. 1: Starter mounting location — 4.8L engines 84903021.gif
    Fig. 2: Starter mounting location — 4.3L and 5.0L engines 84903022.gif
    Fig. 3: Starter mounts — 5.7L and 7.4L engines 84903023.gif

  5. Remove the front bracket bolt or nut. Lower the starter, front end first, then remove the unit from the truck. To install:
  6. Position the starter and tighten all bolts as follows: R/V Series:
    • Thru-bolts: 40 ft. lbs. (54 Nm)
    • Bracket bolt: 30 ft. lbs. (41 Nm)
    • Nut (gas): 11 ft. lbs. (15 Nm)
    • Nut (diesel): 90 inch lbs. (10 Nm)
    C/K Series:
    • Thru-bolts: 35 ft. lbs. (45 Nm)
    • Bracket bolt (diesel): 24 ft. lbs. (33 Nm)
    • Nut (diesel): 75 inch lbs. (8.5 Nm)
  7. Reconnect all wires. Fig. 4: Disconnect the negative battery cable 87982p25.jpg
    Fig. 5: Remove the starter retaining bolts 87982p30.jpg
    Fig. 6: Remove the starter from the vehicle 87982p31.jpg
prev.gif next.gif

Jul 19, 2010 | 1984 Chevrolet Chevy

2 Answers

How do you replace the starter on a 1989 SW1500?


The following is a general procedure for all trucks covered in this manual, and may vary slightly depending on model and series.
  1. Disconnect the negative battery cable at the battery.
  2. Raise and support the vehicle.
  3. Disconnect and tag all wires at the solenoid terminal.
Reinstall all nuts as soon as they are removed, since the thread sizes are different.
  1. Remove the front bracket from the starter and the mounting bolts. On engines with a solenoid heat shield, remove the front bracket upper bolt and detach the bracket from the starter.

f6823f2.gif
Starter mounts-5.7L and 7.4L engines

  1. Remove the front bracket bolt or nut. Lower the starter, front end first, then remove the unit from the truck.
To install:
  1. Position the starter and tighten all bolts as follows:
R/V Series:
  • Thru-bolts: 40 ft. lbs. (54 Nm)
  • Bracket bolt: 30 ft. lbs. (41 Nm)
  • Nut (gas): 11 ft. lbs. (15 Nm)
  • Nut (diesel): 90 inch lbs. (10 Nm)
C/K Series:
  • Thru-bolts: 35 ft. lbs. (45 Nm)
  • Bracket bolt (diesel): 24 ft. lbs. (33 Nm)
  • Nut (diesel): 75 inch lbs. (8.5 Nm)
  1. Reconnect all wires.450af3b.gif

Disconnect the negative battery cable


56132e9.gif
Remove the starter retaining bolts


d54e957.gif
Remove the starter from the vehicle

Apr 26, 2010 | 1989 Chevrolet Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

233 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6528 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...