2006' Dodge Charger will not turn on. New Battery, starter tested and passed. Key tested and passed. It has the factory keyless entry. It worked fine prior.
This has been an issue with the chargers for a while. The starter relays under the hood panel. Usually start to go and takes 2-10 seconds for the starter to kick in.you can swap the relays for same # ones and try.
SOURCE: 2001 Dodge Ram 1500 Keyless Entry/Security System
Your keyless/security system may have been damaged by the spikes. But, assuming you've already checked all the fuses, I would start by having the alternator tested. I would also check the alternator wire connection to the power distribution center (pdc). It can loosen and cause different problems.
Good Luck!
SOURCE: Keyless entry blinks dome light and does nothing else
The remote is fine - your problem is the lock actuators in the doors. They're a bit of a pain to replace - so, you may want to have a professional do it.
SOURCE: SPARK PLUG INSTALLATION ON 2006 DODGE CHARGER 2.7L
In my experience with the 2.7L engine, the spark plugs are located on the top of the engine below the individual ignition coils. The coils are placed between the intake manifold and the valve covers, 3 per side. The coils are held in with "torx" screws. Simply remove the screws, and disconnect the connectors to remove the coils. The spark plugs will be underneath. Be sure to properly gap the spark plugs for maximum life and emissions compliance. Also, an improperly gapped plug can shorten the life of the coil packs.
Hope this helps!
SOURCE: how to program a new remote keyless entry for 2002
1. Press LOCK button 5
times at 2 second intervals to resynchronize remote.
2. Insert key into the ignition switch. Turn ignition
to the RUN position (as far as you can
go without cranking
engine). Wait for ignition chimes to stop.
3. Using the working remote, press and hold the UNLOCK button on the
remote for 4 to 10
seconds.
4. Within the specified 4 to 10 seconds, continue
pressing the UNLOCK button and then
press the PANIC button ( on the programmed remote ) for 1 second and
release both
buttons. A chime will sound to indicate that the remote
programming mode has been
entered ( allow 3 seconds for chime to sound
).
5. Within 30 seconds of the chime, press and release the
LOCK and UNLOCK buttons
simultaneously then press and release just the
UNLOCK button on the same remote.
A chime will sound indicating the
remote has been programmed. Press and release
the LOCK and UNLOCK buttons
simultaneously and then press the UNLOCK button on
each new remote you
wish to program at this time. Locks will cycle after
each additional
remote is programmed.
6. Turn the ignition OFF and remove
key.
7. Test Remotes.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question
4,552 views
Usually answered in minutes!
The remote still opens, locks doors, opens trunk. The panic alarm works fine.
Any mobile mechanic recommendations that will come to 77506 area?
×