Need auxiliry belt routing for my peugeot 807
Cannot seem to upload a pic sorry and it will take me a thousand words but my alldata book only lists the engine numbers and not the models now iam looking at the one i think it is and that goes around the crank top run goes around tensioner with back of belt to this of course then the generator around the next idler up to the PAS then down to the AC and back to the pulley
SOURCE: need routing diagram for 2000 lincoln town car serpentine belt
There's a diagram at this link.
SOURCE: "when do i change the cam belt on a peugeot 307 sw diesel"
usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.
SOURCE: belt routing diagram 98 zx2 2.0
1) Start with the alternator.
2) Forward to the smooth idler
3) Forward to power steering
4) Down to A/C compressor
5) Back to crank pulley
6) Forward around tensioner
7) Back glancing off of water pump
8) Back glancing off of ribbed idler
9) Up around alternator (where you started)
Good luck!
SOURCE: 2006 Dodge diesel belt routing diagram
Here's a link to the diagram you need...
http://www.gates.com/common/part_locator/view_diagram.cfm?id=S8023
Testimonial: "Awesome! thank you so much for the quick response!"
SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan
3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!
Fig. Accessory serpentine belt routing-6.5L Diesel engines
Fig. Accessory serpentine belt routing-6.6L Diesel engines
Hope this helps (remember to rate this answer).
878 views
Usually answered in minutes!
×