After changed the flat tire ; i found my tire sensor damaged ;after that i went to tire repair shop and i found another kind of sensor but it can fit for kia models but the light still on
If you look in your manual, there is usually a procedure for resetting TPMS sensors. They can be as silly as turning off and on the headlights 3 times or honking the horn with the key turned to the on position. If you can't find it in there the dealer will have a tool to reset it for you.
SOURCE: engine light came on kia 2007 rondo
you need to have the code read to see what it is most auto parts store can do that for free that will help use tell you what it is
SOURCE: TPMS light on 2006 Kia Sportage
Your Tire Pressure Management System is extremely sensitive. Some makes are known to trip with just 5-8 psi. difference. Have the pressure checked again on all tires including the spare. Make sure the spare is up to proper inflation. VERY important. It is possible that the sensor inside the tire as well as any wiring associated with the system under the wheel wells could have been damaged. Start by making sure the pressures are all within system range. The owners manual will stipulate this and all info you may need to troubleshoot on your own. good luck.
SOURCE: Low tire 2007 Kia spectra
You can plug any tire as long as it's on the tread face, not in the sidewall. The repair person will know. It makes no difference whether you have TPMS.
SOURCE: change front rotors kia rondo 2007
Remove the tire, remove the brake calipers, 2 bolts on back side of rotor, remove the carter pin that retains the bolt position if equiped, remove the center nut. When you pull the rotor off watch for a set of bearings to drop out. To install the new rotor reverse the process.
SOURCE: disable tpms
I don't know if there is a problem with your TPMS receiver (on dash board), or your TPMS sensor is disable (in four tire). If it's the receiver problem, You have to go to the dealer ship to solve the problem. If it's the sensor problem. You can go to the dealer ship to let them find which sensor or sensors are fault, And replace them by the new one then doing the reset process.
2,819 views
Usually answered in minutes!
×