Hhr rough idle

This code refers to the fuel rail pressure sensor circuit being high. The two most common problems of this code are a faulty sensor and/or faulty pressure regulator. A wiring/computer issue can also contribute to this code. I have had success with numerous vehicles displaying this code by changing the fuel pressure sensor and correcting the problems you have stated

If it stalls when the brake lights come on then the idle is too slow. The high amps of the lights will load down the engine and lowers the idle.

Sometimes that's caused by a vacuum leak near the manifold area.

Sometimes air in the coolant will cause an idle problem. Air will keep the air temp sensor from sending proper info.
Hope this helps.
Sometimes that's caused by a vacuum leak near the manifold area.

Sometimes air in the coolant will cause an idle problem. Air will keep the air temp sensor from sending proper info.
Hope this helps.

Car Stalls and idles low

http://technoanswers.blogspot.com/2012/10/gmc-sonoma-stalls-and-idles-low.html
------------

It can be issue with IAC( idle air control valve) causing the problem.

There are many other possibilities causing these idle issues. Engine idles rough.

There are few help links with solutions to troubleshoot such idle issues.

I suggest you refer the link below and follow its troubleshooting details:------

Click the link below:-----

Ford Expedition IAC valve replacing

http://technoanswers.blogspot.com/2012/12/ford-expedition-iac-valve-replacing.html

Bad miss at idle?

http://technoanswers.blogspot.com/2012/01/bad-miss-at-idle.html

-----------

Stumbling and stalling at idle after engine rebuild?

http://schematicsdiagram.blogspot.in/2012/03/stumbling-and-stalling-at-idle-after.html

------------

1999 Ford F-150 Idles rough and quits when gas pedal is pressed less?

http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html

---------

Engine stumbles coming off idle when warm?

http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html

------------------

Erratic idle on car?

http://schematicsdiagram.blogspot.com/2011/12/erratic-idle-on-car.html

-----------

Cold start problem and vehicle shudder around 2500 to 3500 rpms

http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

----------

Low idle when cold out side?

http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html

-----------

GMC Sonoma Stalls and idles low

http://technoanswers.blogspot.com/2012/10/gmc-sonoma-stalls-and-idles-low.html

--------

GMC Idle Air Control (IAC) Valve Replacing?

http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html

-------------

1996 Camry intermittent engine failure while idle?

http://repairhelpcenter.blogspot.com/2011/10/1996-camry-intermittent-engine-failure.html

------------

Engine quits at idle?

http://repairhelpcenter.blogspot.com/2011/10/engine-quits-at-idle.html

-----------

Car overheats and Air blows hot at idle?

http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html

---------

High Idle Problem

http://repairhelpcenter.blogspot.com/2012/10/high-idle-problem.html

-------

While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------

Idle flair is noticed on car? Rough idle? car will not idle? Erratic idle speed?

http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html

--------

High rpm in neutral? Inconsistant high RPM in neutral?

http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-------

Vehicle stumbling at idle and shows code 54?

http://schematicsdiagram.blogspot.in/2012/03/vehicle-stumbling-at-idle-and-shows.html

----------

Rough idle, staling and Erratic shifting?

http://technoanswers.blogspot.in/2012/03/rough-idlestaling-and-erratic-shifting.html

-----------

While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------

These details will help.

Thanks.

Code 37 is torque converter clutch solenoid failure. Transmission wont shift in and out of overdrive.

It can be issue with IAC( idle air control valve) causing the problem.

There are many other possibilities causing these idle issues.Engine idles rough.

There are few help links with solutions to troubleshoot such idle issues.

I suggest you refer the link below and follow its troubleshooting details:------

Click the link below:-----
Bad miss at idle? http://technoanswers.blogspot.com/2012/01/bad-miss-at-idle.html

-----------
Stumbling and stalling at idle after engine rebuild?

http://schematicsdiagram.blogspot.in/2012/03/stumbling-and-stalling-at-idle-after.html

------------
1999 Ford F-150 Idles rough and quits when gas pedal is pressed less?

http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html

---------
Engine stumbles coming off idle when warm?

http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html

------------------
Erratic idle on car?

http://schematicsdiagram.blogspot.com/2011/12/erratic-idle-on-car.html

-----------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

----------
Low idle when cold out side?

http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html

-----------
GMC Sonoma Stalls and idles low

http://technoanswers.blogspot.com/2012/10/gmc-sonoma-stalls-and-idles-low.html

--------


GMC Idle Air Control (IAC) Valve Replacing?

http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html

-------------
1996 Camry intermittent engine failure while idle?

http://repairhelpcenter.blogspot.com/2011/10/1996-camry-intermittent-engine-failure.html

------------
Engine quits at idle?

http://repairhelpcenter.blogspot.com/2011/10/engine-quits-at-idle.html

-----------
Car overheats and Air blows hot at idle?

http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html

---------

High Idle Problem

http://repairhelpcenter.blogspot.com/2012/10/high-idle-problem.html

-------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------
Idle flair is noticed on car? Rough idle? car will not idle? Erratic idle speed?

http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html

--------
High rpm in neutral? Inconsistant high RPM in neutral?

http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-------
Vehicle stumbling at idle and shows code 54?

http://schematicsdiagram.blogspot.in/2012/03/vehicle-stumbling-at-idle-and-shows.html

----------
Rough idle, staling and Erratic shifting?

http://technoanswers.blogspot.in/2012/03/rough-idlestaling-and-erratic-shifting.html

-----------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------

These details will help.

Thanks.

Clean the throttle body and check or replace the idle control valve. Also check or test the throttle position sensor.

you can check your idle air contol senser or you could have a bad fuel injector

TRY THIS BEFORE U SPEND ANYMORE MONEY N PARTS.
Here is the common cause of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

On thing to check is the air duct hose that connects from the throttle body to the air cleaner housing. If it gets cracked it will cause stalling problems and very rough idle.

hello first check your idle with the car running foot on brake see were your rpm reading is if your below 500rpm check your label underhood for your curb idle setting second see if theres a adjustment screw you can increase were your gas cable lever rest against your set screw underhood if you feel confident enough remove your iac motor idle air control valve if the bore were the end of the pintle extracts out to close has varnish builup our carbon it will stick creating vacuum leak type senario causing stalling rough idle sometimes even no start conditions good luck