1994 Chevrolet Camaro Logo
Anonymous Posted on Feb 05, 2012

Clutch starting to slip 1994 camaro can i adjust it

After engaging clutch in 1st and 2nd gears the rpm spikes but car is sluggish. is there a way to adjust the clutch or should i replace it now before i have to pay for a tow. Camaro is a 3.4ltr v6 problem just started last night. i was in fifth gear about to exit highway on coming car sped up and then slowed down i had to brake hard and maneuver out of his way before i down shifted i press gas pedal to floor i was doing about 40mph while still in 5th i could smell the clutch.... any advice. this morning when i backed out of my driveway no problems. when i shifted to 1st it started to roll forward then rpm spiked to 4000rpm no power to wheels i shifted to 2nd began to get power to wheels at about 15mph it spiked again to 4000rpm i up-shifted to 3rd and regained power to wheels. so far only slipping in 1st and 2nd

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Master 2,187 Answers
  • Posted on Feb 05, 2012
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: Jun 03, 2009
Answers
2187
Questions
0
Helped
559956
Points
6379

It does sound like your clutch needs replacing. Adjusting the clutch may help but will not solve the problem. If the transmission has not been serviced for a long time it is a good idea to replace the transmission fluid, inspect the pressure plate. They may also start to wear.

Testimonial: "thanks Nicolo where is the adjustment on the clutch.. i going to change the tranny fluid right now. i hope that helps."

  • Anonymous Feb 05, 2012

    Please see this linkhttp://www.ehow.com/how_4484774_adjust-c...

    I would advise caution in doing the procedures mentioned. Also to add, if you feel that the clutch has lost resistance when applying pressure you may want to check the clutch slave found at the end of the clutch line at the transmission.

×

3 Related Answers

Anonymous

  • 22 Answers
  • Posted on Apr 06, 2009

SOURCE: rpm`s spike up and down

I don't wanna laugh but the Vibration of the defrost is probaly wiggling a connection --most likely a harness ground on the engine bay firewall ---I'd check the grounds then the throttle position sensor connector connection and then the --Don't laugh distributor connections to inlude the engine to cab ground cable ---braided bare cable from the block to the firewall -

--the COIL pack may have a poor connection ---and I believe if correct on blazers the feed wire to the coil from the harness
is thick and pinkish that connection if loose describes the symptoms exactly

nothing works without a sufficient GOOD gound --loosen and retighten and ground wires-positive wires and connections ----GM is well known for wiring harness problems ---my 84 blazer
happened to share the same ground for the Blower motor and the distributor ---not anymore!
check your connections and those grounds --am I repeating myself ---and also continue to seek help in here if still persisting after that ---should only take 15 minutes to check it all
30 to fix most likely
hope this helps
HAWK

Ad

Anonymous

  • 607 Answers
  • Posted on May 25, 2009

SOURCE: valve spike,no exceleration,or power

Check for clogged fuel filter. Hope this helps

steve_e_uk

steve morris

  • 1675 Answers
  • Posted on Mar 18, 2010

SOURCE: coolant temperature gauage spiking

hi, this sounds like your fan not cutting in at the right time, when you are in traffic it will get hot as the fan is not doing its job, but when you are driving the water is getting cooled by the air comming in through the grill, there might be a couple of things that will need checking, first one being the thermostat, as this is most likely thing to go wrong, then the fan switch on the radiator could be faulty, air in the system is another cause, try bleeding the system and se if you get air out and finally temp gauge switch, this could be a fauls possative, ie, nothing overheating just the switch giving wrong reading, theres a few things for you to be checking....hope this helps

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Problems selecting 1st gear peugeot 106 1.1 zest

If the clutch is a problem you will have difficulty selecting 1st only as the gears would be spinning from the engine revs.. I would say that the front input shaft (clutch shaft) bearing is failing allowing miss alignment of the synchros and not allowing proper engagement of the gears synchro rings. It means removal and repair to the gear box so the clutch can be inspected while the box is out.
1helpful
1answer

1998 Saturn SC1 manuel stick is hard to shift into 1st & 2nd gear

Try to double clutch the clutch pedal. How to double clutch; push the clutch in moving the stick to neutral, then release the clutch and then push it back in and shift into first or second gear. If it works then it is not the shift linkage and could be a clutch adjustment. First how far do you have to release the clutch pedal until the clutch plate starts to engage? If only an inch or so the clutch pedal needs to be adjusted, which is an easy fix (this is more common). The other possible problems could be the clutch plate, throwout bearing of syncros could be bad. If it is one of the previous problems double clutching should buy you some time.
0helpful
1answer

Have 1st 2nd and reverse, no drive 1988 model 2 wd

sounds like 3rd gear clutch is out (it might have blew out a lip seal or something)
pull the pan c if there is a lot of black on the bottom of pan (no 3rd = no 4th either) the 3rd gear clutches are engaged along with the 4th gear clutches to make overdrive
if the tcc cable is out of adjustment it mite shift at wot (wide open throttle) max rpm (5000-5500)
if it just 1,2, neutral its probly clutches
0helpful
1answer

Rpm spikes

it sounds like the bands on the transmission are slipping if it is an automatic trans if it is a manual the clutch is slipping if auto take to dealer. if manual adjust the clutch cable out some it connects to the transmission with a thick cable near the bell housing tighten the cable to give it less play 3 or 4 turns
0helpful
1answer

Peugeot 205 1.2 Junior, Slipping Clutch

see if thete is any adjustment left in the clutch cable if not then you will require a new clutch
1helpful
1answer

I have a 2003 vw golf gt tdi 130 6 speed and have lost 1st and 2nd gear. I have checked the cables and they are working fine, the selector is moving but the gears are not engageing.

CHECK CLUTCH CABLE! IF CABLES IS LOOSE YOU COULD HARDLY ENGAGE 1ST AND 2ND GEAR.
IF YOUR CAR IS USING CLUTCH CABLE, ADJUST IT
IF IT USES FLUID, CHECK THE RUBBER CAPS.
0helpful
1answer

My mustang feels like it's slipping

I have this sane issue on a 2006 Mustang, I thought it was the Clutch, have been adv's by for it is not, but I am not to sure, happend 1st and 2nd gear

Ken
Not finding what you are looking for?

438 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...