Question about 2006 Nissan Altima

2 Answers

Reset Nissan Altima seatbelt light which is flashing

I removed the passenger sweat and disconnected the wires. When I reinstalled the seat and reconnected the wires, the seatbelt light is flashing in the dash.

Posted by Ralph Giugliano on

Ad

2 Answers

Johnny Brown

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 5,763 Answers

A scan tool is needed to reset the seatbelt light, unhooking the wires turned the light on as a fault, a scan tool will reset code. also make sure all connectors are connected good, the computer may reset itself after it sees a few key cycles and tests the system and it passes but it may take awhile. i have seen some that will stay on until they are reset, if the light is still on after all this time then a scan tool will be needed to turn off the light. good day.

Posted on Feb 04, 2012

Ad

Crystal Burns

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My seat belt light is staying on what can I do

Posted on Jul 10, 2019

Ad

5 Related Answers

Anonymous

  • 324 Answers

SOURCE: 1994 Nissan Altima Passenger Door won't open

Since you have the door panel off, pul the rod for the door lock manually inside the door, this should unlock it, if it does not, there is a small push button, basicly a little peice of metal on the latch itself on the door latch inside the door, push it down this should pop the door open, you may need to spray all of the mechinisms with white lithium grease in a arosol can.....

Posted on Nov 26, 2008

Anonymous

  • 14 Answers

SOURCE: 2004 Nissan Altima passenger side low beam

I would look at the fuses also. these newer cars have seperate fuses for driver an passenger headlights.

Posted on Oct 13, 2009

techbuster

INDIRA KUMAR

  • 5081 Answers

SOURCE: How do I change the passenger side headlight bulb on 2001 Altima

Open up the hood, and go in behind the fixture where the light is located. Sometimes there is an access panel on top. Open it and reach down inside and grab the bulb’s socket. Twist the socket a quarter turn counter clockwise, and pull out the socket. Grab the bulb, and pull it straight out. To replace the new bulb, never touch it with your bare fingers, as this will greatly shorten the bulb's life, if it even work's at all. Use a tissue or something else in that order to handle the new bulb. Push the new bulb into the socket, put the socket back into the housing, and twist a quarter turn clockwise to secure the socket into the fix.Seems that you have to remove the coolant bottle(two screws), and also the unscrew the washer fluid bottle, after that you can reach the socket that holds the bulb. There is a wire that holds the bulb in. if you loosen the screw you can tip up the wire and be careful to leave it in place...also the long side of the wire seems to connect to ground wire for the light...

Posted on Oct 14, 2009

Anonymous

  • 10 Answers

SOURCE: 2000 nissan altima: driver side seatbelt is in

Take the bolt out of the top of the seat belt and release the pressure on it.If this doesnt work the safety module will have to be replaced.

Posted on Jan 18, 2010

fingaz22

michael schultz

  • 1068 Answers

SOURCE: 2001 Nissan Altima front power seat does not move

needs a forward/rearward motor. it has two separate motors under the seat. very common and i replace them all the time. good luck

Posted on Mar 26, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I safely disconnect and bypass the passenger seat airbags for permanent removal of the seat?


As for the removal of passenger seat, you need to disconnect first the battery terminals, wait another minute or two, before.you begin the removal job. As for the bypassing procedure, it is not.encouraged here. You need to find a pro. If it is possible, separate the airbag component from the seat and let it remain connected to the system, like a seatbelt buckle or pretensioner. If it is not possible, you will need expert services regarding the bypass procedure. After getting the job done, recheck all connectors and harnesses to its proper place before you reconnect the battery terminals.

Jul 13, 2018 | Seat Cars & Trucks

1 Answer

Seat belt light flashes after seat belt is on


The new 2013 Bentley Mulsanne Mulliner has the same thing.I know on the Bat Mobile it means the ejector seat is not fully charged.

The only generic answer I can conclude with information you provide is ;

1) The passenger seat of a newer general motors car

2) The seatbelt light does not light up when the seat is not occupied

3) The passenger side Airbag (SRS) has been turned OFF

4) While occupied , the seatbelt light on the insrument cluster lights steady

5) when the seatbelt is active (buckled with a passenger) the light flashes.

6) anybody?

Mar 31, 2013 | Cars & Trucks

1 Answer

I have a 2005 ford crown victoria P71 ( interceptor). It has cruise but dosent work. I just bought it from the county. It was a active patrol car that was up for replacement (so its in excellent mechanical...


I also have that same vehicle but, I'm sorry to say it does not have cruise. I also have a wiring issue. I replaced the interior (seats, carpet, door panels, and a few dash moldings) with duel power seats, however I through out the old seats before I noted the "wiring colors" for the passenger seat 'seatbelt' and 'airbag' sensor connections. The new seats came out of a 2003 crown vic (not a p71) and had totally different connections under the passenger seat. My '05 p71 did not even have the wires there for a power passenger seat, so I had to replace and wire them in from the harness that I removed from donor car. That actually wasn't TOO bad, and the seats work fine, but I don't know which wires go together for the seatbelt and airbag sensors, as the old wire 'colors' under the seat do not match the 'colors' on the connectors under the new power passenger seat. If you could tell me the colors of the wires to your original seat (passenger), for the seatbelt and airbag plugs you would be a great help in solving my issue with the "airbag" and "seatbelt" light that stays lit on the dash. If I can help with your problem in some way, even though my car does not have cruise, e-mail me and let me know how ([email protected]) .

Dec 18, 2011 | 2005 Ford Crown Victoria

1 Answer

The seatbelt light in the gauge on the dashboard keeps flashing on and off. Passengers wear seat belts when driving..... I have disconnected the battery, recently to replace a burned out head light bulb....


Dear,

the blinking light only indicates the belt position of the Driver seat only.
if you click the seat belt in the fixer.......you will find the light getting off....

thanx

May 16, 2011 | 2004 Nissan XTerra

2 Answers

Seat belt alarm wont stop beeping


Check for wire disconnected where you plug your seatbelt into. it will probably go under the carpet a bit, but it is there. If it is broken/disconnected, the alarm will continue to sound. There is one in the passenger side too, but should only sound when a passenger is seated unless you have more than one problem here...

Oct 09, 2010 | 1987 Toyota Camry

1 Answer

2006 Vue front passenger seat removal


Seatbelt bolt (t-50 I think) & 2 15mm bolts then rock the seat forward & it's out. Disconnect the electrical connections first

Jul 29, 2010 | 2006 Saturn Vue

1 Answer

Air bag light started coming on /dash constantly


the likely fault is the cables running to the seatbelt pre-tensioners under the drivers or passengers seat in the front of the car.

This may be simply the plug and socket have become seperated from sliding the seat back to clean, a common fault, or the airbag "clockspring" connection unit in the steering wheel has a broken ribbon cable inside the column housing.

To see if its the airbag clockspring, buy a 4 ohm resistor from maplin or radio shack, disconnect the battery on the car, unplug the airbag in the steering wheel and connect the resistor across the 2 contacts in place of the airbag, reconnect the battery, if the light goes out the clockspring is the fault, if not its the SRS system wiring under the seats.

Jan 10, 2010 | 2000 Audi A4

1 Answer

Seat motor issue


If you look under the front seats you will find electical plugs.Make sure they are clean and connected.Disconnect the plugs with the baerry earth wire disconected.clean and replace,then reconnect baterry wire

Nov 09, 2009 | 2004 Infiniti FX35

1 Answer

Seatbelt light on


There is a tiny switch under the **** area of the seat that tells the car someone is sitting there... and a tiny switch in the seatbelt CLICK mechanism. These only have 2 wires which go down to the floor, alongside the running board and up to the dash. The switch nder your **** is NormallyOPEN and CLOSES (makes contact) when someone weighing 50lb or more sits in the seat (smart huh) It could be bent, broken, come loose from its moorings or have a wire loose... At the same time, the passenger seat also has shcu a switch and it might be STUCK or shorted. Same for the seatbelt CLICK mechanisms on both sides. If you don't like loosening seat bolts, pulling up carpeting and removing the inside panels, etc. what we call 'troubleshooting'. find someone that does - or take it to a dealer.

Jan 15, 2009 | 1999 Ford Crown Victoria

1 Answer

Air bag light


hi this may be a long shot ? but if you have auto seat belt pretensioners ie activate on impact ? try under your seat and look for the wire/plug connector these sometimes are cause of light illuminating try this? disconnect plug and clean then re connect see if light off do same on passenger seat constant moving/adjusting seat position ? or inadvertantly catching the wire underseat when vacuuming car are a common cause of loose contacts ?

Oct 13, 2008 | 2005 Hyundai Tiburon

Not finding what you are looking for?
2006 Nissan Altima Logo

2,189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...