Follow the rubber tubing from the passenger side, from where the fluid exits back towards the resivor and u will find a tee fitting where the tubing splits from pasenger to driver side. take it apart and blow compressed air thru it.
Check that the line does not have a hole in it (could make sure it is dry and then try it and then go back and check for dampness on line) and that it is connected properly. It may also be blocked so you could try disconnecting it before the nozzle and checking if water comes out of the tube. If so it is the nozzle which is blocked so you could try cleaning it out with a pin.
SOURCE: wind shield wipers stop in center of window
Sounds like a linkage (wiper transmission) problem. But, put an external ground wire to the wiper motor first and see if they work then.
Also many wipers have a fastening nut on the wiper arm where it attaches to the stub that goes through the body. These may have loosened and gone out of adjustment. If so, loosen them and re-position arms, then tighten them down.
SOURCE: windshield wiper on driver's side of Hyuandi doesn't work -
I recently had the same problem of the drivers side wiper not working. My boyfriend (a mechanic) took the windshield cowl off and looked to see what was going on. He originally thought that maybe something had slipped off. I'm going to describe what he found in layman's terms. When you take off the wiper blade arms from the wiper transmission assembly unit there are these silver colored nubs with grooves on them (one for each wiper). What he found was that on mine the grooves were stripped so that the wiper on the drivers side wouldn't catch and go across the windshield while the other wiper worked fine. What we think that happened is that I left the wipers on when I shut off the car and since we had a huge snowstorm the wiper transmission bound up and stripped the nubs when I turned on the vehicle the next day and let it warm up. I had tried for the past week to find a used replacement wiper transmissions assembly but was not successful. I just ordered the part from my local Hyundai dealer at a cost of $180. I will at least save on the labor, as my boyfriend can handle that part. If you try to get the part used, be careful. There was a product change mid-year. Prior to June 2004 (If I remember correctly) is one part number and Santa Fe's manufactured after that date is a different part. I needed the earlier Santa Fe part. You can look at the body panel between the front and back doors on the driver's side for the production date of your vehicle there is a metal decal with the vin, your color codes, and other information.
SOURCE: Need to drain the wind shield washer fluid container
No drain plug..
Should only be a few screws to remove it so you can empty it out..
Hope this helps !!
rate me good ;o)
SOURCE: 1999 vw beetle. blinkers, wind shield wipers not working.
check the electrical part of your ignition switch . this is common to burn out and is easy and inexpensive to fix .does not require anything to be done to the mechanical part of the switch and key.
SOURCE: wind shield wipers stopped working, wiper motor
I have the same problem with my 1989 Dakota. I found a part: A-1 CARDONE Part # 40387 which is listed as a Wiper Motor. Is that the same thing?
186 views
Usually answered in minutes!
×