Question about 2005 Chevrolet Venture

1 Answer

2005 chevy venture brake lights not working. 3rd light works. fuse looks good. changed switch. what left to check?

Fuse looks fine. i changed the brake switch. the light above the rear door works.

Posted by Grant Fisher on

Ad

1 Answer

Ricky Peters

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Chevrolet Master
  • 2,620 Answers

Try this push down on brake pedal while you push in or wiggle the hazard switch.If the brake lights come on then that means you turn signal switch is faulty.

Posted on Jan 15, 2012

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My brake and hazard lights don't work on my 2001 Chevy Astro Van. Turn signals work fine, running lights work, and the top brake light works fine. Replaced bulbs, no change, fuses are fine. Where do I look...

Buy a cheap multimeter and measure your voltage at the bulb when the brake lights are supposed to be on. You should have 12vdc. Is your 3rd brake light and brake lights on the same fuse? If not, measure to see if you have 12vdc at the fuse itself.
0helpful
1answer

1 brake light doesn't work... good bulb and fuse

Lights are usually on a dual circuit! Left and right have separate fuses, check all fuses or check the fuse diagram on fuse cover or manual to identify correct fuse!
0helpful
1answer

Lower brake lights no longer work on my 2002 chevy tahoe but the 3rd brake light works fine. Checked fuse and bulbs and everything works fine. Just the 2 lower brake lights dont work.

Most of the time the problem is in the turn signal switch. The third brake light circuit bypasses the turn signals.
Someone would need to check brake light power in and out of the turn signal switch.
3helpful
1answer

CRUISE CONTROL WON'T WORK ON 2005 CHEVY TRAILBLAZER

check cruise control fuse and check the brake lights see if brake light working because the brake light switch will deactivate cruise control when brakes is applied.if brake lights dont work either fuse blowed or switch bad.if all is good have vechicle code scan because cruise control control by PCM and vechicle speed sensor and thottle actuator control motor.
0helpful
1answer

2005 chevy venture a/c button

Test the switch itself. If the switch is providing continuity look to the A/C control module for your Venture.


Control Module
0helpful
1answer

Unable to find out why the upper brake light work but the lower two by the tail lights don't on a chevy venture 2004 the bulbs look good and the fuse isn't back and have been replace, what else good it be...

The power to brake lightlights goes through the signal switch, have some one watch while you hold brake pedal and wiggle signal lever to see if lights come on, if they do then its a bad signal switch, also check to make sure the hazard button is not on, try turning on the 4way flasher and then try brake
1helpful
1answer

2005 Chevy Trailblazer no brake lights, but third brake is working....

The body mounted brake lights, are on a different fuse than the upper light. Check fuse #12 a 25amp fuse in the fuse block under the hood on
the left fender. The upper light fuse #16 a 10amp fuse in the rear fuse
block, under the left side of the back seat. Hope this helps.
0helpful
1answer

Chevy trailer brake problem

Check under hood fuse box make sure L. trailer light fuse isnt blown.
0helpful
1answer

Rear Brake Lights not working, 3rd light is working

check the fuse for the stoplights. Even though the 3rd one is working it should be on a different fuse. With both of them not working even after you changed the bulb it would seem to lead to a fuse.
0helpful
1answer

Chevy venture

Solution to your problem ... 1- I purchased from 1aauto.com a pair of Circuit Boards for my Chevy Venture 2003 for 85.00 $ ..free shipping 2 - I Installed them both , all lights now were not working at all. So I checked them and they were all burned ...So I purchased new ones ....Everything was working fine now but now my signal lights were not working left and right .....Checked the fuse box next to the passenger side door .... It was burned . Changed the fuse / Signals are working fine now ....All is good I just did this yesterday evening August 12, 2008 Conclusion ..Change everything going forward so you do not need to run around like I did from one store to another!
  1. Circuit Board : New
  2. Bulbs : New
  3. Fuses : New
Thank you
Not finding what you are looking for?
Cars & Trucks Logo

481 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

john h

Level 3 Expert

24102 Answers

Ryan Lutton
Ryan Lutton

Level 3 Expert

1266 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14874 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...