Question about 1998 Jeep Grand Cherokee

1 Answer

Car wont start no power at all

Will jump just fine, but otherwise no power when trying to start. no interior lights at all. after waiting about five to ten minutes the interior lights will work, but the car still wont turn over. one of my grounds is loose but it was just hanging around the engine so i dont know where to hook it up. also my interior fuse box makes a clicking noise

Posted by Anonymous on

Ad

1 Answer

Rick M

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 4,033 Answers

And the mystery vehicle is?

Posted on Oct 10, 2017

Ad

4 Related Answers

Anonymous

  • 7 Answers

SOURCE: 2004 Liberty will not start

the solution for your problem is your starter went out. the price for a used starter will run at about 50 to 100 dollars and for a new starter it will run at about 150 to 175 dollars.

Posted on Aug 19, 2008

Ad
MrScary66613

Travis Humphries

  • 1990 Answers

SOURCE: Power windows, locks, and seat not working

That Clicking should be a Bad Relay Switch. See if you can Locate it and Replace it. It should fix this Problem for ya! Please Rate My Response! Thanks!

Posted on Jan 31, 2009

El Geek

Carlos Soto

  • 149 Answers

SOURCE: Hanging, but when i press the arounding space of touch pad its works otherwise hang

I have only seen this similar issue once before. I was working on a laptop that had that same issue. After dissmantling the laptop and putting it back together it had the same issue. Turns out that when the motherboard bent a certain way, it would work. Technically speaking, once the board bent enough it made contact with whatever was NOT making contact. Her situation was solved by replacing the motherboard for a new one. I don't know if that is the route you should take though. But it sounds just like the problem I fixed before. Good luck.

Posted on May 22, 2009

Richard Scordino

  • 6982 Answers

SOURCE: My 2002 Jeep Grand Cherokee Laredo won't start.

Check that your battery has 12v, check and clean terminal contacts. If battery has less than 12v have it charged and load tested. 9 of 10 times this will get you going...if not, I'll give you the rest of testing later if you need it.

Posted on Sep 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Put in a new fuel pump car still won't start has a security light on what do we do to get it started


If the Security Light is on but is not flashing, the security system is fine. If the security light is flashing then turn the ignition key to the run position (do not start). Wait over ten minutes and then try to start the engine. After the ten minutes you should notice that the light stopped flashing. If the engine starts then you do have a problem with the Passlock Security System.

Feb 28, 2014 | Mercury Grand Marquis Cars & Trucks

1 Answer

I have 06 Sonata and when my ESC light comes on I can't drive my car at all. I have to pull over with my hazords lights on and wait for about five to ten minutes until something happens. Its reall


When a warning light switches on because of a fault, the fault should be recorded in the computer memory and suitable diagnostic equipment should reveal approximately what is happening.

Aug 05, 2017 | 2006 Hyundai Sonata

1 Answer

2002 vue v6...starts and runs well however when I stop , shut off the engine, then try to start after half hour , it wont start


Lookfor a light on the dash that says SECURITY or ANTITHEFT. If you see this light, that is a sign of a failed or failing antitheft system, which will disable your vehicle. This link explains

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Nov 06, 2011 | 2002 Saturn VUE

1 Answer

Changed battery and replaced lost key. Now it won't start


nitabelle57, It sounds like your security system will not recognize the new key you purchased. Keys have a chip in them which has to be recognized by the security system in order to work. The new key has to be programmed by your security system before it will start your vehicle. You will need a battery charger to program the key as this procedure takes thirty minutes to do. Put the charger on the battery. Be sure everything else is turned off. Place the new key in the ignition and turn it to the run position. The security light should come on. After ten minutes the security light should be out, if not proceed anyway. Turn the key to the off position but do not remove it. Wait five seconds and turn it to the run position once again. Wait another ten minutes and turn it off again. Wait five seconds and turn it to the run position once again. After the final ten minutes turn the key off (do not remove it) Wait thirty seconds and then the key should be programmed. If you have any other keys they will not work now as the security system is now programmed for the one key. If you have another key and need it for another driver then start the vehicle with the newly programmed key and let it run for about a minute. Place the extra key in the ignition and turn it to the run position and wait sixty seconds. This should solve that problem. Good luck with this.

Aug 10, 2011 | 1997 Pontiac Grand Prix

1 Answer

Security light keeps blinking in my five hundred and the car will not turn over. It cranked fine an hr ago, but now nothing


Try and disconnect the battery for ten minutes. During that ten minutes, take some sand paper, and scrub down every terminal metal surface on that battery and the cables to bright and shiny. Then, rehook the battery. Put the key in the ignition, and let it set for 20 minutes. I think that will get it going again.

Jun 27, 2011 | 2005 Ford Five Hundred

1 Answer

I jump started someone else's car with my good battery now the "service stabilitrak" light came on and i have no power steering


Try disconnected the ground cable from the battery, wait ten minutes and hook it back up. This should reset everything.

May 20, 2011 | 2008 Chevrolet Equinox

2 Answers

My 2003 Pontiac Montana van is a 6cylinder the larger of the montana's and I went to start it today it made a click noise after I turned the key not while I was turning the key,and the interior lights...


Perfect example of a dead battery. When they go, they go quickly. The plates shed material very gradually over the years. When that material piles up high enough in the bottom of the battery, the battery short-circuits itself--even if it started the car just fine ten minutes prior. Jump start the engine to get home or to the auto parts store. The alternator will supply the power to keep the engine running. (Don't turn off the engine 'til you're back home!)

Aug 31, 2010 | 2003 Pontiac Montana

2 Answers

Car will not start after battery power lost for 24 hours


Hello,I am Ron,sorry to say,but you will have to go to the dealer and have the computer reprogrammed.The battery power lose caused the ecm to loose all memory.Not much to do but go to the dealer.

Aug 16, 2009 | 2005 Pontiac Grand Prix

Not finding what you are looking for?
1998 Jeep Grand Cherokee Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...