Question about 1994 Jeep Grand Cherokee
You will need a 13-inch wiper blade for the rear window. 1 - When removing the wiper blade lift the wiper arm away from the window. ----- 2 - With one hand holding the wiper arm press the small tab on the underside of the wiper blade where it meets the wiper arm. ----- 3 - Slide the wiper blade off of the arm by pulling the center toward the bottom of the arm.----- 4 - Lightly lay the wiper arm on the window.----- 5 - Prepare your new wiper blade by taking the curved part of the plastic clip and line it up with the curve of your wiper arm. ----- 6 - Lift the wiper arm and press it through the center of the wiper blade up and over the plastic clip. 7 - Pull the wiper blade up until it clicks. Place the arm back on the window.
Posted on Jan 11, 2012
My 97 Jeep Grand Cherokee was doing the same thing. I changed the TPS ( Throttle Position Sensor) Now it is great goes into overdrive fine. It is really easy to change.
Posted on Feb 11, 2009
You can check fluid level by removing the rubber plug in the cover. Fluid is full when on level ground, it is just at the edge of the hole (or very close) if you are already getting noises out of there, you can remove the cover and inspect gears for wear or breakage. If you find a large amount of metal debris in the lube it tells you something bad is going on back there. Although rebuildable, it's not a home job...requires exact settings in order to operate properly. You can find good units far cheaper than even a gearset costs in any scrapyard. to match ratio, count the teeth on the ring gear and the pinion gear. the replacement MUST have the exact same number. Before swapping diffs, check all back there to make sure noise is not from somewhere else.
Posted on Jun 20, 2009
Traced the problem to the Lamp Outage Module located in the rear left quarter access panel behind the spare tire. Arcing had occurred on the left taillight line. Fortunately this part is readily available at your local Jeep recovery yard (none available in the U.S. from dealers). Recommend J& W Auto Wreckers in Antelope, CA (web site available). Massive number of Jeeps and fair prices. If you don't want to replace the LOM then you can join the two connectors that go into the LOM (LOM is optional) but you'll always show a lamp failure on your console.
Posted on Nov 08, 2009
Take it to any parts store and they will do it for you for free, there are three types, the rocker type which you have to raise the wiper arm away from the glass then pull the tab up then slide the wiper down and slide the wiper off the wiper arm. but the best thing is have someone show you how to do it for the first time sometimes they can be tough to get off.
Posted on Jan 19, 2010
Testimonial: "Thank you for the info it is very helpful."
Tips for a great answer:
Nov 25, 2013 | 2004 Jeep Grand Cherokee
Nov 12, 2017 | Cars & Trucks
Feb 04, 2013 | 1999 Jeep Grand Cherokee
Jan 07, 2012 | 1993 Jeep Grand Cherokee
Apr 02, 2010 | 1994 Jeep Grand Cherokee
Mar 09, 2010 | 1999 Jeep Grand Cherokee
Feb 10, 2010 | 1999 Plymouth Grand Voyager
Sep 24, 2009 | 1998 Jeep Grand Cherokee
Jan 25, 2009 | 2000 Jeep Grand Cherokee
353 people viewed this question
Usually answered in minutes!