Timming belt i have a honda accord 2.2 motor and i am changing the timeing belt i knoe there are 2 belts the main belt and a small one the main belt is already aligned but the small belt does not have any marking to use how do i line up the small belt

Hi the balance shaft has to set by removing the bolt in the engine block that is in line with the front of the balance shaft the get a 6mm bolt that is 100mm long slide it into the hole where you revoved the bolt turn the balance shaft keeping a slight pressure on the bolt until it locates the hole in the shaft and locks it up then if you look at the oil pump there is a mark on the top of the housing and the oil pumps shaft just line them up stick your belt on tension and remove the locking bolt yates210456

There is a bolt you need to remove and insert a longer 6mm about 2 1/2 inches long to align the right balance shaft. the bolt is on the right side of the engine. there is a notch on the other shaft on the left. and a pointer on the block just to the top of the shaft... hope this helps good luck jimmy