03 cadillac cts dtc p0141, p0161 and p0036

No code tells you to replace a part , need to do diagnostic's for said code .
P0141 - O2 Heater Circuit (Bank 1, Sensor 2) Description: See the description for DTC P0135. Possible Causes: See the possible causes for DTC P0135. Diagnostic Aids: See the diagnostic aids for DTC P0135. Application Key On Engine Off Key On Engine Running Continuous Memory All GO to Pinpoint Test DW .
DW: Heated Oxygen Sensor (HO2S) DW: Introduction DW1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS) Are DTCs P0040, P0041, P0053, P0054, P0055, P0059, P0060, P0132, P0133, P0135, P0138, P0139, P0141, P0144, P0147, P0152, P0153, P0155, P0158, P0159, P0161, or P1127 present?
Yes No For DTCs P0040 or P0041, GO to DW2 .

For DTCs P0053, P0054, P0055, P0059 or P0060, GO to DW14 .

For DTCs P0132, P0138, P0144, P0152 or P0158, GO to DW20 .

For DTCs P0133 or P0153, GO to DW3 .

For DTCs P0135, P0139, P0141, P0147, P0155, P0159 or P0161, GO to DW9 .

For DTC P1127, GO to DW19 . For all others, GO to Section 4, Diagnostic Trouble Code (DTC) Charts and Descriptions .
DW9 DTCS P0135, P0139, P0141, P0147, P0155, P0159 OR P0161: CHECK FOR A SOURCE OF POTENTIAL HO2S CONTAMINATION

• Investigate the following items as potential sources of HO2S contamination:
  • use of unapproved silicon sealers
  • fuel contaminated by silicon additives
  • excessive oil consumption
  • glycol leaking internally in the engine
  • lead-contaminated fuel
  • short drive cycles in cold weather
  • use of unapproved cleaning agents

Is a concern present?
Yes No REPAIR the source of the contamination.

CHANGE the engine oil and oil filter.

RESET the keep alive memory (KAM). REFER to Section 2, Resetting The Keep Alive Memory (KAM) .

REPEAT the self-test. GO to DW10 .

Here's a link for codes P0446,P0443. https://www.obd-codes.com/p0446 Here's the link for P0403. P0403 Exhaust gas recirculation EGR circuit malfunction Here's code P0135 P0135 OBD II Trouble Code O2 Sensor Heater Circuit Malfunction Bank 1... Here's code P0141 P0141 OBD II Trouble Code O2 Sensor Heater Circuit Malfunction Bank 1... Here's code P0155. P0155 OBD II Trouble Code 02 Sensor Heater Circuit Malfunction Bank 2... Here's the last code.yay P0161. P0161 OBD II Trouble Code HO2S Heater Circuit Malfunction Bank 2 Sensor 2... The last 3 codes might just be one sensor.

If the sensors were replaced an DTC'S come back has to be a wiring problem or PCM ,
The ECM detects that the HO2S heater low control circuit voltage is between 2.6-4.6 volts when the heater is commanded OFF, indicating an open HO2S heater circuit.
Is the fuse open?
All four codes refer to the heating element circuit ! there is a relay in the under hood fuse box that supplies B+ voltage to the O2 sensor heating elements . I would change that or test the relay , videos on you tube on testing relays .
MAIN Relay
--
LO SPEED Relay, HI SPEED Relay, S/P FAN Relay, PRE O2 Fuse, IGN-1 Fuse, ECM Fuse, POST O2 Fuse, and INJ Fuse
Also check
POST O2 Fuse
10 A
HO2S Bank 1 Sensor 2 and HO2S Bank 2 Sensor 2
PRE O2 Fuse
10 A
Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1 and HO2S Bank 2 Sensor 1

Cadillac CTS Questions - codes P0036 & P0141 come up ...

www.cargurus.com > Questions > Cadillac > CTS
CarGurusJul 24, 2014 - codes P0036 & P0141 come up on scan tool O2 sensor heater circuit malfunction bank 1 sensor2 my question is where is this - These codes ...

Yes there is something in common . Check the fuse # 79 10amp in the underhood fuse box . For O2 sensor , heater power .
The PCM commands the heater ON or OFF to maintain a specific HO2S operating temperature range. The PCM monitors the voltage on the HO2S heater low control circuit for heater fault diagnosis. If the PCM detects that the HO2S heater low control circuit voltage is not within a specified range, DTC P0030 sets for HO2S 1, or DTC P0036 sets for HO2S 2.
So this is not in spec. an it set the other codes !
If the PCM detects that the heater current or the heater calculated resistance is not within an expected range, DTC P0135 sets for HO2S 1
If the PCM detects that the heater current or the heater calculated resistance is not within an expected range, DTC P0141 sets for HO2S 2.

Check your fuse and replace any that are burnt out. It is possible that it your heater on your O2 sensor shorted that it blew the fuse.

In order to get the light out you will have to replace the rear O2 sensor.

code p0054 is
Possible causes - Faulty Heated Oxygen Sensor Bank 1 Sensor 2
- Heated Oxygen Sensor Bank 1 Sensor 2 harness is open or shorted
- Heated Oxygen Sensor Bank 1 Sensor 2 circuit poor electrical connection
When is the code detected?Heater current requirements too low or high in the heated oxygen sensor (HO2S) heater control circuit Symptoms- Engine Light ON (or Service Engine Soon Warning Light)
code p0141 is O2sensor heater circuit malfunction( bank one sensor 2)
there is chance that wire from that sensor is touching,part of your exhaust system,and either is open or shorting to ground

code p0036
036 - HO2S Heater Control Circuit Bank 1 sensor 2check the wire from the sensor for the sign cut or melting,and change the sensor

All 3 codes are point to the o2 sensor
the one you want to replace is on the exaust manifold looks like a spark plug with a wire sticking out of it un plug the sensor and it turns to the left to get off install the new one and plug the new sensor in
Thanks

P0141=O2 Sensor Heater Circuit Bank 1 Sensor 2
P0161=O2 Sensor Heater Circuit Bank 2 Sensor 2,
the 141 code is a problem with the heated O2 sensor on the drivers side exhaust after the converter,
the 161 code is the same except it is on that passenger side exhaust after the converter.