Can a code be flashed on the ABS LIGHT by jumper setting in the ecu unit
SOURCE: VW Bora, The ABS alarm
fuse box in top of battery has a cable connected to the positive side of battery and it might be loose. Tight it and alarm should go away.
Posted on Sep 03, 2008
SOURCE: bmw 520i 1999 abs/asc lights on diagnostic
Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car
Posted on Jul 08, 2009
SOURCE: ecu not communicating audi a6
what about one of these re-conditioning places or a go to scrappers and find a smashed one and get the ECU and the chip out of the key.If this vehicle is a europeon built one for the europeon market but ended up in stateside then the problem could be that the software is encrypted and your dealer doesnt have the encrypted version of the software and i doubt if they will be able to obtain it either .
Posted on Aug 16, 2009
SOURCE: replace side marker light on lexus rx300
Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.
Posted on Aug 18, 2009
SOURCE: ck engine light of Lexus Rx300 code is 171 sistem
YOU COULD HAVE AIR LEAKS AFTER THE MASS AIR FLOW SENSOR OR IN THE EGR OR PVC SYSTEM.YOU HAVE A MECHANICAL FAULT AFFECTING ONE OR MORE CYLINDERS EXHAUST LEAKS LOCATED IN FRONT OF THE A / FS OR HEATED OXYGEN SENSOR LOCATION.FUEL SYSTEM SUPPLYING TOO LITTLE FUEL DURING CRUISE OR IDLE FAULTY FUEL PUMP OR FUEL FILTER.FUEL INJECTOR ONE OR MORE DIRTY OR PRESSURE REGULATOR HAS FAILED.THESE ARE THE POSSIBLE CAUSES TO YOUR PROBLEM.
Posted on Sep 23, 2009
Oct 10, 2017 | Lexus Cars & Trucks
Jun 02, 2016 | Lexus Cars & Trucks
Feb 17, 2015 | 1999 Volkswagen Passat
The ABS light coming on means that the computer is seeing a problem with the ABS system, which won't set the CEL light, especially since the ABS system has nothing to do with the engine. You need to have someone scan the system for all codes, soft and hard. And then let us know what you find out.
---------
gm tech2 scanner
Jan 23, 2013 | 2001 Lexus RX 300
Jul 02, 2011 | 2001 Jaguar XJ8
Apr 13, 2010 | 1999 Lexus RX 300
Jul 02, 2017 | 2001 Lexus RX 300
Dec 19, 2009 | 1999 Lexus RX 300
Mar 09, 2009 | 2006 Toyota Tundra
489 people viewed this question
Usually answered in minutes!
×