Some on pulled the spark plug wires of my metro and I need to know were spark plug number 1 is so I can replace them
On GM inline engines,cylinder #1 is the one closest to the front(pulley)end of the engine. If you pulled the wires off the distributor/coil pack,and don't know where they go,put one wire one at a time and crank it.If it doesn't backfire,repeat until it starts.(this is only easy on 4 cylinder or smaller engines)
Testimonial: "thanks that will help me fix my problem"
SOURCE: 97 geo metro spark plug firing order
3cylinder is 132
4 cylinder is 1342
distibutor turns counter clock wise.
SOURCE: 1995 Ford F350 5spd. distributor cap wiring diagram/layout!!!
1) #1-4 pass side front to rear #5-8 drivers side front to rear
2) 1-3-7-2-6-5-4-8
3)#1 is usually marked on cap wires go ccw
4) TDC #1 cyl you must remove the shorting plug before timing
it is located by the dist plug or the ignition module small gray plug
SOURCE: Whats the spark plug setting on 92 Geo Metro?
you mean the gap?
Plug gap is 0.39 thousands of an inch.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question
SOURCE: Check engine light flashing
the fuel injector is not pulsing correctly,it probably has something in the screen in side of it,you will need to check that screen in the injector or replace it
SOURCE: my 94 geo metro runs very rough and has
you should check a throttle body valve or purge valve, choke valve
573 views
Usually answered in minutes!
×