International 9400 9200 9900 heat box is under the passages side seat. That where the heater core location and the ac evaporator blower. You have two control motors under there one control the bunk for hot and cold. The other control front for hot and cold. Defrost vent and front vent is in the dash. My suck on defrost and in floor will open to front vent. I have not locate yet.
where is the defrost vent located inside the dash
Where is the defrost located in the dash of a international 9400i
Also how do you change a fan clutch on a 9400i International?
×
SOURCE: There is no air flow
You need part GM Part number 89018675 or ACDelco 15-73596. The Mode Selector Actuator. What happens is the part is a CHEAP part POORLY designed and when it goes to turn the flaps inside the HVAC unit its the plastic gear slips instead of turning the flap!!!
Just to forward you you might want a deal to install this art for you unless your good at fixing your own vehicle, because you need SMALL sockets and a lot of patience to get this part in!!!
The part is ALMOST directly above the steering shaft for your steering wheel, so theres a lot you got to remove before you will even see them!!!
I only recommend you to have a dealer put this part in for you, unless you have your own service manual!!
Because there is 5 of these darn things and if you pick the wrong one you will have to do it all over again!!!
3 on the Drivers side and 2 on the Passengers side!!
But replacing this part SHOULD solve all your problems!! AS it did for me and i was having the same issues as you have described!!
SOURCE: Vent control
You have a vacuum leak.Defrost is the default postion(no vacuum).
See if you can locate the small black vacuum line that goes inside the vehicle on the passenger side near the heater core. The trace it back,should see it going to a canister then to the intake manifold.Make sure it is not disconnected or broken somewhere.
SOURCE: climate control system only blow air out defrost vent
there is a good chance that you blend air door is stuck closed over your heater core and therefore not allowing the heat to flow, also your door that opens and close your direction of flow from the floor ,das,vent and defrost.your going to have to remove the lower cowling of the dash on the passenger side analso some of the center dash to actually check to see if the cable,servo motors. are acuating the doors.the issue could be just a stuck door or a misaligned cable or that it came off. that falls under the mechanical side of probabilities. electrical would most likely be a faulty selector switch or a servo motor
SOURCE: Heat wont blow through heater or defroster vents
common problem, check under dash by the gas pedal if control arms are muving went selecting from ac to heat cuz this it is the control for the vents to go from ac to heat and to defrost.
SOURCE: PROBLEM WHEN SELECTING THE DIRECTION FOR THE AIR
Sounds like you have a supply vacuum problem. When you lose supply vacuum to the control head it defaults to defrost.
9,725 views
Usually answered in minutes!
×