An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert who has written 50 answers of more than 400 characters.
Re: How can I reprogram my Jaguar X Type Key so I can...
If your just programming the fob to the module and it has not been replaced and your just needing a manual reset,then follow the folowing procedure:
1 Insert key into ignition 2 Turn key to 'I" 3 Turn key "II" and back to 'I' quickly 4 times 4 Alarm system will chime once when key is back to 'I' for the fourth time 5 Remove key from ignition 6 Press any button on each key fob and alarm system will chime for each fob if it has been programmed correctly 7 Press unlock/lock/trunk etc to make sure everything works
Testimonial: "Thanks so much! I found out that my battery needed to be replaced ugh had to get it towed to Jaguar dealership.. cost me an arm and a leg! Thanks again!"
Add Your Answer
Tips for a great answer:
- Answer the question.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
sounds like the pats (passive anti theft system) is not recognising the chip in the key try a spare key if you have one if not try to get it reprogrammed you may have to go to a jag dealer to sort this out may be the reluctor coil around the ignition barrel has gone faulty
If the car goes "beep beep" when you try to lock the doors something is still open. otherwise Sounds like a defective keyfob try a new battery, try your spare if you have one. If you don't have a spare you should get one anyway. You can match your new keyfob to the car by following instructions here:= http://www.bluejag.co.uk/X-Type-keyfob-reprogramming.php
Have both keys to hand. Rapidily flick the ignition to position 1 four times until you hear a chime then press the unlock key on both remotes. A chime should be heard each both times when you press the buttons
hi, try disconecting the battery for a couple of hours and try again but make sure you have your stereo code. if this does not work your key fob may be out cync with your ecu and will require reprograming it is easy on x type , you can do it your self ,you can find the instructions in jag forums or ebay for 1.99
It sounds like they disconnected your battery when they worked on your car.... Try this and see if it works..
1-insert and remove key from ignition two times
2-close and open driver door two times
3-insert and remove key once from ign.
4-close and open drvr door twice
5-insert key into ign.,then close driver door
6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.
7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.
8-press lock/unlock together and hold for a second
9-release,and press lock on remote,the door locks will cycle
confirming program.continue to do other remotes you have,steps 8 and
9.if only one in possession,you are done. To end mode open door or insert key into ignition.
You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works
I recently changed the batteries in the key of my 2001 Audi TT. To reprogram it, I needed to take this 1 key to the vehicle, click on the unlock button and within 1 minute, open the driver side door manually with the key. It worked.
Your key fob needs reprogramming, and yes the alarm will go off when you open the door, but you have enough time to put the key in the ignition which will prevent the alarm sounding. Car is usable until you get the fob sorted by locking and unlocking using the key.