Question about Chevrolet Cars & Trucks
The driver seat will not adjust forwards or backwards. The passenger adjust with no problem.. so i have deduced that it is not the fuse. Also all connections seem securely fastened. I activate the adjusted on the side of the driver seat and nothing happens, not even a noise like it is trying to move. So question is if it is not the fuse, and likely its not the connections, what could be causing it to have no response when activated?
My power seats on my 09 Impala have stopped working. Neither the passenger seat nor the drivers seat work. What can it be?
Posted on Aug 05, 2018
I have a 2007 Impala. Thank you razor67 for the tap. I did not even remove the seat motor. All I used was an 18 inch rod and a hammer from the rear and hit the motor a couple of times and it's freed.
Posted on Dec 21, 2015
It can also be theseat motor since there is seperate motors for up/down & forward/backwards. You can test the switch to see if you are getting power to the connector on the motor by using a multimeter.
If there is power to the motor, I would remove the motor and give it a tap on the ground. Alot of the time the motor is fine, and the tap will free it up again. If it doesn't work you may be up for a new seat motor. Giving mine a tap solved the issue with mine.
Posted on Nov 05, 2009
Replacement parts and labor could run $200 + from the dealer.. Yes, a replacement switch can be obtained from a salvage yard, BUT NOT from an auto parts store. It is not difficult to remove old switch and replace
Posted on Apr 04, 2009
Electric or manual??? If electric one of the motors has gone out. If the kids were playing with it they may have held the button down causing the motor to spin while the seat was all the way foward and it will just burn the motor up after so long. Also the switch could be bad. Unfortunatley being that its power there is no way to manually move the seat back without the motor turning or removing the seat and spinning the motor sprocket by hand...
Posted on Sep 10, 2009
Well what I saw when I pulled my seats out of my 97 LC was that the worm gear on the bottom of the track had lost some tread. (its plastic) also, there is a cap that screws in to the end of that gear to hold it in place, so when you reverse the seat, the gear moves if that cap falls out of place ----small plastic cap fell out in mine. The whole rail system is like $300 at Toyota but i found a website that sells the cap and the gears for $20. I will try to post it tomorrow-for the time being, you can take the seat out -be sure to unplug the electronics, and use a wrench to manually move the seat back and then put it back into place
Posted on Nov 23, 2009
Tips for a great answer:
Jan 16, 2017 | 2003 Cadillac Escalade
Jan 10, 2015 | Ford Cars & Trucks
Sep 28, 2014 | Cars & Trucks
Aug 03, 2012 | 2004 Honda Pilot
Jul 29, 2012 | 2006 Kia Optima
Aug 12, 2010 | Mercedes-Benz E-Class Cars & Trucks
Jun 07, 2009 | 2007 Jeep Liberty Sport
Aug 25, 2008 | 2001 Lincoln LS
Jul 19, 2008 | 1993 Chevrolet Corvette
7,511 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: