Question about 2003 Mini Cooper

4 Answers

Eml on my mini coopers

When the eml lights come on the , the speed reduces

Posted by swaziby on

Ad

4 Answers

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 3 Answers

The engine control unit has detected a fault light illuminated which in turn reduces ability to gain high revs as a damage limitation exercise , known as limp home , car requires diagnostic computer to check fault codes to indicate faulty component causing ecu to go into limp home mode

Posted on Oct 13, 2008

Ad

Sarah harris

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

EML light an ASCT light an emissions light on and gone into limp mode help I've only just bought it

Posted on Apr 21, 2017

Ad

luis

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

I changed spark plugs, wires and bobin and problem fixed.
it's usually caused cause a any electrical malfuction related directly to the engine; from a loose wire to a bad conected spark plug wire. i really recomend a mechanic that knows about this cars, remember that they are basicly new in our continent. i love my mini!!!!!

Posted on Jun 19, 2012

gus tangas

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

I went out to start my 2002 mini this morning. it started, but it would not rev up
more than 2000 rpm. I put it vin gear but it would not go over 2000 rpms.
Any suggestions as to what the problem ?

[email protected]

thanks!!

Posted on Feb 12, 2012

  • Bonifacio Leon Dec 19, 2019

    Check if your EML light is on.

×

1 Related Answer

fastboyz

paul erickson

  • 674 Answers

SOURCE: eml on my mini coopers dash board

you have a problem in your emissions and you need to get the code pulled so you can find the problem

Posted on Sep 28, 2008

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Eml light warning is on and the 2006 Mini Cooper S lost power, the car also had a misfire (P0303) . I replaced the spark plugs, wires and coil pack. Problem still here,


misfires are also caused by low fuel pressure injector electronics faults and faulty injector tips . Replacing plugs is half the fix

Aug 10, 2014 | 2006 Mini Cooper S

1 Answer

O6 MINI COOPER EML LIGHT


You will need to go to a auto parts store and use their OBDII Reader.

Jul 14, 2014 | 2007 Mini Cooper Convertible

1 Answer

My mini cooper s 2003 is turning engine off automatically when I reduce the speed like at roundabouts and trafic lights showing the engine light and EML on the dashboard. As soon as I turn on the engine...


Remove both battery cables, hold them together without touching the battery, for 30 seconds, then reinstall battery cables. This resets the ECU, then drive normal. See if it helps!

Dec 03, 2013 | Cars & Trucks

1 Answer

Mini Cooper S Engine Management Light


The following are descriptions from the Mini-Cooper S owner's manual.

Service Engine Soon "?If the warning lamp comes on
either continuously or intermittently, this indicates a malfunction in the emissions-related electronic systems."

EML light: "Engine electronics ?Malfunction in the engine electronics. You can continue to drive with reduced engine output or engine speed."

Triangle circled by an arrow: "Automatic Stability Control plus
Traction (ASC+T)/Dynamic Stability Control (DSC)
?Indicator lamp flashes: System active: drive and braking forces are regulated.
The indicator lamp stays lit: ASC+T/DSC switched off with button or defective. In the event of a defect: please have the system inspected at your MINI Dealer."

First, inspect the belts to make sure none failed at high RPM. If one broke, inspect any cable or hoses in the plane of the belt to see if there was any damage (e. g., a ripped wire in the ASC+T/DSC system). Second, get a readout of the engine error code. (If you get indications of a major vacuum leak including rough idle, look for a blown head gasket.) If you get something else, please post the results in a comment so we can go to the next step.

Jul 09, 2017 | Mini Cooper Cars & Trucks

1 Answer

EML engine electronics light


some fault codes stored in your car,
try to use car diagnostic tool check it

Apr 19, 2012 | 2007 Mini Cooper Convertible

1 Answer

I was driveing my mini cooper and the engine managent light came on then went out then came back on and the eml light came on as well and wont go out


You need to take your car to Autozone to get the computer scanned. The lights are on because the computer picked up a problem with your car. They will scan it for free. They will tell you what the problem is and will probably tell you the parts you need. Try to go asap, it may get worse. Then you will know why the lights are on. If you need anything else, fell free to contact me. I am here to help in anyway I can. Thank you for using FixYa.

Feb 15, 2011 | 2002 Mini Cooper

2 Answers

Eml on my mini coopers dash board


Try reading the obd2 code with your phone and this cheap device

Sep 28, 2008 | 2007 Mini Cooper S Convertible

Not finding what you are looking for?
2003 Mini Cooper Logo

6,136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mini Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mini Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...